Emerson Fisher 249VS Gebruiksaanwijzing - Pagina 3

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Emerson Fisher 249VS. Emerson Fisher 249VS 16 pagina's. Cageless displacer sensor
Ook voor Emerson Fisher 249VS: Gebruiksaanwijzing (16 pagina's)

Instruction Manual
Form 5831
November 2007
CONTROLLER OR TRANSMITTER
(TYPE DLC3010 SHOWN)
W8150 / IL
Figure 3. Torque Tube Arm Exploded View Showing Controller or Transmitter Mounting

Installation

WARNING
To avoid personal injury or property
damage resulting from the sudden
release of pressure:
D Always wear protective clothing,
gloves, and eyewear when performing
any installation operations.
D Check with your process or safety
engineer for any additional measures
that must be taken to protect against
process media.
D If installing into an existing
application, also refer to the WARNING
at the beginning of the Maintenance
section of this instruction manual.
Type 249VS is installed directly on the vessel as
shown in figure 4. The sensor mounts on the side of
the vessel using an NPS 4 flat face or raised face
flange.
Because the displacer hangs inside the vessel,
provide a stillwell around the displacer if the fluid is
in a state of constant agitation to avoid excessive
POSITIONING
PLATE
RETAINING
FLANGE
ROTARY SHAFT
MOUNTING HOLES ACCEPT
FOUR STUDS OR CAP
SCREWS DEPENDING ON
CONTROLLER OR TRANSMITTER
turbulence around the displacer. For interface or
fluid level applications, install a gauge glass on the
vessel.
Figure 5 provides overall envelope dimensions for
the 249VS sensor and DLC3000 Series controller
and figure 6 provides overall envelope dimensions
for the 249VS sensor and 2500 Series controller or
transmitter.
Cageless 249VS Sensor
OUTER
GASKET
TUBE
END
NPS 4 RF FLANGE
NOTE:
1
STILLWELL REQUIRED AROUND DISPLACER IF THE FLUID
IS IN A STATE OF CONTINUOUS AGITATION
W9356
Figure 4. 249VS Sensor Top Mounted on Vessel
TORQUE TUBE
ARM
HEX NUTS OR CAP SCREWS
DEPENDING ON CONTROLLER
OR TRANSMITTER
249VS
DISPLACER
1
STILLWELL
3