Gallien-Krueger 400RB/115 Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Gallien-Krueger 400RB/115. Gallien-Krueger 400RB/115 16 pagina's. Artist series
Ook voor Gallien-Krueger 400RB/115: Gebruikershandleiding (16 pagina's)

Gallien-Krueger 400RB/115 Gebruikershandleiding
The 400RB Series is designed to be simple to operate.
All controls have a well defined purpose and are well
behaved. These directions will take you through the
basics and give you a good start for setting up your
sound.
Set the power switch to Off and connect the supplied
power cable from the amplifier AC receptacle to an AC
power outlet of proper voltage and power rating (see
safety information on page 7 for details).
Connect your speaker cabinets to the amplifier
outputs marked 240W. Be sure not to exceed the
recommended speaker load listed below.
One 4 Ohm, or two 8 Ohm cabinets.
If you are using an RBH series cabinet, set the
crossover switch to full range.
Set all EQ controls and the Boost control to 12
o'clock. The Voicing Filters should be turned all the
way down to get a flat response. Set the Volume and
Master Volumes at 0. If you have a five string bass,
push the button marked String Bass in.
Using an instrument cable, connect your bass to the
Input jack and turn the power switch on and play. If
the clip LED flashes, push the button marked
in. This will prevent you from overdriving the preamp.
Set the master control to 12 o'clock and slowly bring
the Master volume up. Do not turn the Volume
control in the input section past 12 o'clock unless you
want an overdrive effect. If you have a bass with
passive electronics make sure the controls are all the
way up. If you have a bass with active electronics,
turn all of the EQ controls on the bass to the middle
or flat position.
You should be hearing your bass quite well. You can
use the Volume and Master to achieve a comfortable
sound level.
turn up the Master control first.
If you need more volume,