Gallo Tech GTS-3RS Bedienings- en installatiehandleiding - Pagina 2

Blader online of download pdf Bedienings- en installatiehandleiding voor {categorie_naam} Gallo Tech GTS-3RS. Gallo Tech GTS-3RS 16 pagina's. Keyless rfid push button start & security system

1.1 INTRODUCTION

GTS-3RS has been designed to eliminate the need for an ignition key to unlock, start and stop the vehicle,
and provide a high level of security. GTS-3RS makes use of a sophisticated electronic technology called Passive
RFID (Radio Frequency Identification). This technology allows all the same functions done by an ignition key but
completely hands free. Example: just walk up to the vehicle with the RFID key FOB in your pocket or purse and the
doors will unlock automatically. After sitting in the vehicle the driver can press the "Start Stop Engine" button one
time momentarily and the accessories will turn ON, OR Press and hold the "Start Stop Engine" button and the
Ignition will turn ON or will start if the brake is pressed. Put it in gear and drive away. To turn the vehicle off simple
push the "Start Stop Engine" button for 1.5 sec. and the engine will stop. After opening the door and walking away
from the vehicle, the doors will automatically lock and the accessories will turn OFF. Functions such as trunk
release, car locating, an auxiliary channel, shock sensor, and other security functions are standard with GTS-3RS.
Installation Requirements for GTS-3RS:
1. Automatic transmission only. (GTS-3RS is not for use with a manual transmission.)
2. If the vehicle is equipped with a locking steering column, the steering column lock must be
disabled. Mechanically locking steering columns can be disabled by removing the steering
column shroud and key lock assembly and removing the column locking pin. A cut key blank
method can also be used. Insert a cutoff key blank in the ignition and turn to the ON position. This
method requires that all electrical connections to the ignition key be disabled.
3. Vehicle can be gasoline or diesel. Fuel injection is preferred. Carbureted engines typically are not
compatible with Remote Start operation.
4. If the vehicle is equipped with a factory security key system, a security by-pass module will be
required (not included). The by-pass module will be activated when GTS-3RS is in the start and
engine running mode. Security by-pass modules are specific to each vehicle make, model, year.
These vehicle specific bypass modules can be supplied by the installer, or can be purchased
through aftermarket by-pass module suppliers such as "Xpresskit" or "Fortin Electronic
Systems". We do not recommend using "IDataLink" modules as they are not compatible with
GTS-3RS.
5. Vehicles must have a properly functioning Park/neutral safety switch.
6. Must have a properly functioning emergency brake with a negative (-) switch.
7. Requires operational (positive (+) or negative (-)) door pin switches.
8. Power door locks are required for maximum security & convenience.
9. GTS-3RS must be connected to the parking lights.
To ease and reduce installation time, we suggest you consider the following points before starting:
1. Check all vehicle manufacturer cautions and warnings regarding electrical service (AIR BAGS, ABS BRAKES,
ENGINE / BODY COMPUTER AND BATTERY). Use extreme care and do not probe any wires of the SRS
system.
2. Additional vehicle specific wiring diagrams and other helpful installation information can be found on our web site
at
www.gallotech.com/support.php
3. Determine the most suitable locations for all components to be placed. These components include: The control
module, "Start Stop Engine" button, siren or possible extra relays.
4. GTS-3RS can be installed with or without the ignition switch. If the ignition switch is left functional then the
vehicle can be started with either the key or the "Start Stop Engine" button. The column lock however, must be
disabled. See Figure 1 Option 1 (page-10)
5. Use a Digital Multi-Meter or 12-volt Test Probe (High-Impedance) to test and locate all connections.
Conventional Test Lights can damage a vehicle's computer systems.
6. Record all color codes of vehicle wiring to be used for reference. This will save time by not having to re-test the
same wires over again. Mark all vehicle wires with masking tape.
7. After locating and marking the appropriate wires, DISCONNECT the (+) POS terminal at the battery.
8. Determine the type of door locking system the vehicle has before connecting any wires. Incorrect connection can
result in damage to the GTS-3RS and/or vehicle locking system. There are several types of door lock systems in
vehicles today. Listed below are many types of common locking systems:
Negative Trigger (-): Many Imports; Late model Ford & General Motors (Figure 3 page 13)
Negative trigger door lock systems send a Negative (Ground) pulse to existing factory relays to lock and
unlock the vehicle doors.
Positive Trigger (+): Many General Motors; Chrysler / Dodge / Plymouth (Figure 4 page 14)
© Copyright Gallo Technologies. All Right Reserved
IMPORTANT:
READ ALL INSTRUCTIONS BEFORE INSTALLATION
- 2 -
061515V54RS