Cor HA-6400 Handmatig - Pagina 5
Blader online of download pdf Handmatig voor {categorie_naam} Cor HA-6400. Cor HA-6400 10 pagina's. Setup using the tp-link router
S Click on the Learn button
S TAP a magnet (i.e. from a Door/Window Sensor) to the vertical line mark on the side of the TX−E611 Sensor
S A message will appear that a New Device Found
S Enter a description under Sensor Name
S Select the appropriate Sensor Type i.e. "2 24 Hour Audible"
S Select "12 Water Leakage" for Sensor Option
S "Tamper" should be defaulted as checked and do not check "Disable Internal Reed"
S Select Voice Name(s) at the bottom
S Click Save at the top when finished
S Click OK if a popup message appears to confirm your changes
Learn the TX−E611 Water/Freeze Sensor to the Côr Panel as a Freeze Sensor
S Select Sensor to Configure for the next available slot i.e. "6 Sensor"
S Click on the Learn button
S HOLD a magnet (i.e. from a Door/Window Sensor) for at least 2 Seconds to the vertical line mark on the side of the TX−E611 Sensor
S A message will appear that a New Device Found
S Enter a description under Sensor Name
S Select the appropriate Sensor Type i.e. "2 24 Hour Audible"
S Select "13 Low Temp" for Sensor Option
S "Tamper" should be defaulted as checked and do not check "Disable Internal Reed"
S Select Voice Name(s) at the bottom
S Click Save at the top when finished
S Click OK if a popup message appears to confirm your changes
Step 10 — Learn the IS−ZW−LM−1 Z−Wave Light Dimmer to the Côr Panel
S Go to Settings and select Zwave Add/Remove from the dropdown menu under Settings Selector
S Click Add button
S Press the center button repeatedly on the Z−Wave device
S The device will display under the Zwave Device Selector field when the panel learns the device
S (Optional) Select the Device Room Location created earlier
S Enter a description under Device Name
S Click Save at the top when finished
S Click OK if a popup message appears to confirm your changes
Step 11 — Add Wi−Fi Credentials; Create Web Access Passcode and Download Access Code
S Go to Settings and select Network from the dropdown menu under Settings Selector
S Under Wi−Fi Configuration, enter the login credentials found on the sticker underneath the TP Link Router
S
Wi−Fi SSID = myHVACxxxxxx (case sensitive)
S
Wi−Fi Security Type = WPA2 Passphrase
S
Wi−Fi Password = Security Key (8 digit number)
S Change the Web Access Passcode to an eight (8) digit number that you and homeowner agree to use e.g. 4 digits of a number repeated
twice '12341234'
TIP: Write down this Web Access Passcode and panel serial number in the Homeowners Quick Start Guide (01−811−20439−01) brochure in
the Starter Kit.
5