Cor IBR200 Snelstarthandleiding - Pagina 5

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Cor IBR200. Cor IBR200 7 pagina's.

11/2/2020

Understanding LEDs

The IBR200 router uses LED lights on the front panel to communicate various status conditions. Use the table below to verify the status of your router after

the 1-minute bootup cycle.

STATUS

INDICATOR

POWER: The Cradlepoint IBR200 must be powered using an approved 54 VDC power source.

SIGNAL STRENGTH: LED bars indicate the active modem's signal strength

EMBEDDED MODEM: Indicates connection status for the embedded (internal) modem.

https://customer.cradlepoint.com/s/article/COR-IBR200

COR IBR200 IoT Router Quick Start Guide

BEHAVIOR

No Light = Not receiving power. Check the power switch and the power source

connection

Green = Powered on

Blinking Green = Powered by battery

Yellow = Attention is needed. Log into NCM and use the Remote Connect menu

to access the router's NCOS to manage the alert.

Examples: Battery at less than 20%; default Password is unchanged, endpoint

is not registered in NCM, etc

Blinking Yellow = The battery needs to be replaced or the installed battery can

only hold 60% or less of its original capacity.

No Light = Wi-Fi is not operating.

4 Solid Bars = Strongest signal.

1 Blinking Bar = Weakest signal (a blinking bar indicates half of a bar).

4 Blinking Bars = SIM door is not installed, modem is off.

No Light = Modem is not connected.

5/7