Dynex DX-32L151A11 Firmware bijwerken - Pagina 2

Blader online of download pdf Firmware bijwerken voor {categorie_naam} Dynex DX-32L151A11. Dynex DX-32L151A11 2 pagina's. Téléviseurs acl de 32 et 37 po
Ook voor Dynex DX-32L151A11: Handleiding voor snelle installatie (2 pagina's), Handleiding voor snelle installatie (2 pagina's), Gebruikershandleiding (11 pagina's), (Snelle installatiegids (2 pagina's), (Frans) Installatiehandleiding Rapide (2 pagina's)

11. Reconnect the power cord to the wall outlet for the TV; the TV will automatically start

the firmware upgrade process

unit has been plugged in) TV will auto power on.

a. Note: this may take several minutes

12. During the upgrade process, the power indicator will flicker in red and blue (see photo

below); the flickering of the power indicator light may take 15 -20 seconds before

starting once the device has been plugged in.

13. After completion, the TV will auto power on and the power indicator light will display

blue and the TV will display the message "Please Wait..."(this message only appears

for a few seconds)

a. Note: If the process takes more than 5 minutes, that means the upgrade failed.

Please remove the file from the USB drive and repeat the process.

b. If the upgrade fails again contact Dynex at 1-800-305-2204.

14. The upgrade is complete when the "Please Wait..." message disappears

15. While the TV is still turned on; remove the USB device

16. While the TV is still turned on; disconnect the AC power wait 10 seconds, then reconnect

the power cord to the wall outlet.

17. The process is now complete.

(do not

press any buttons on the remote or TV once the

Insert USB device

here

Indicator light will

flicker red and blue