Galvin Specialised Ezy-Wash TF78WC-ESS Product Installatie Manuallijn - Pagina 4

Blader online of download pdf Product Installatie Manuallijn voor {categorie_naam} Galvin Specialised Ezy-Wash TF78WC-ESS. Galvin Specialised Ezy-Wash TF78WC-ESS 4 pagina's. Food service tapware

Pagina afdrukken

TROUBLESHOOTING

PROBLEM

CAUSE

Jumper valves are worn or damaged

Taps are dripping

water

Tap seat is damaged

Water is leaking

O-ring on jumper valve spindle

from spindle

is damaged or worn

Water is turned off

Water is not

Aerator or flow regulator is blocked by

flowing from tap

debris

Spindle is difficult to

Build up of scale on spindle, spindle

turn (jumper valve)

worn or o-ring has been damaged

Handle is loose

Screw has come loose

Hook bracket is loose

Tap assembly

vibrating

Grub screws have loosened

SERVICE AND MAINTENANCE

Turn off the water supply and turn on the tap handle to drain water from the bodies.

Remove the temperature indicator from the handle.

Remove the handle from the tap.

Unscrew the top assembly from the body.

Check the o-ring on the spindle and the jumper valve for wear and damage. Replace if required.

Clean the spindle and body of debris.

Place a new o-ring (if required) onto the spindle and re-grease with potable water approved grease.

Re-assemble top assembly. Follow the product installation guidelines for the relevant product re-assembly

method.

WARRANTY

The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty Ltd. With

respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied. Galvin Engineering

Pty. Ltd. hereby specifically disclaims all other warranties, express or implied, including but not limited to the implied

warranties of merchantability and fitness for a particular purpose.

Galvin Engineering Pty Ltd products are covered under our manufacturer's warranty available for download from

www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the product is free from

operational defects in workmanship and materials for the warranty period as shown on the schedule in the

manufacturer's warranty. During the warranty period, Galvin Engineering will replace or repair any defective products

manufactured by Galvin Engineering without charge, so long as the terms of the Manufacturer's warranty are complied

with.

The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for breach

of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any incidental, special or consequential

damages, including without limitation, lost profits or the cost of repairing or replacing other property which is damaged

if this product does not work properly, other costs resulting from labour charges, delays, vandalism, negligence, fouling

caused by foreign material, damage from adverse water conditions, chemical, electrical or any other circumstances

over which Galvin Engineering has no control. This warranty shall be invalidated by any abuse, misuse,

misapplication, improper installation or improper maintenance or alteration of the product.

RECTIFICATION

Replace jumper valve

Refurbish tap seat using a reseating tool.

Replace o-ring

Turn water on

Remove aerator and/or flow regulator from tap and

remove debris. Install an inline strainer.

Remove jumper valve, clean and regrease. Replace

o-ring. Complete SBA may need to be replaced.

Tighten handle screw

Tighten hook bracket ensuring adequate tension.

Tighten 4 grub screws in body