Dyno DynoStart DS2 Technische informatie

Blader online of download pdf Technische informatie voor {categorie_naam} Dyno DynoStart DS2. Dyno DynoStart DS2 2 pagina's.

DynoStart

Description

DynoStart is a battery powered electronic blasting machine for initiation of

NONEL

tube.

Electrical energy is converted into a strong shock wave of high temperature that,

when applied inside a NONEL tube by the means of an electrode, initiates the

tube. DynoStart uses a common 9V battery and a durable electrode. Both battery

and electrode are easy to change. The electrode can be removed from the blasting

machine at any time to prevent unauthorised usage. DynoStart is designed to

require the use of both hands when initiating the blast.

unintentional firing of a blast.

No part of the device is explosive in nature. It is not approved for use in confined

areas which may contain flammable gas e.g. underground coal.

Dyno Nobel Asia Pacific Pty Limited (ACN 003 269 010) is a subsidiary of

Version 8

Incitec Pivot Limited (ACN 004 080 264) Level 8, 28 Freshwater Place, Southbank Vic 3006

February 2017

Phone 1800 251 872 Fax 07 3026 3999 www.dynonobel.com

DS2

™

This is to avoid

Technical Description

The DynoStart blasting machine consists of an energy source, a voltage

converter, a capacitor for energy storage, a voltage supervision circuit, an

electrode and switches for control.

Electronic energy is converted into a strong shock wave of high temperature which

is applied inside the NONEL tube, by means of the electrode, giving reliable

initiation.

Instructions for Use

To be used for the initiation of NONEL lead-in lines, either NONEL Starter or

NONEL Lead Line. After the pattern has been prepared for blasting in accordance

with local regulations and is ready for firing, use DynoStart in the following way.

Preparation

Cut the end of the NONEL lead-in line with a knife or approved cutting device and

discard the end seal. Insert the cut of the NONEL tube into the chuck on the

DynoStart, ensuring that the tube end is inserted to the bottom of the chuck.

Technical

Information