Dynojet Power Commander III Installatie-instructies - Pagina 3

Blader online of download pdf Installatie-instructies voor {categorie_naam} Dynojet Power Commander III. Dynojet Power Commander III 4 pagina's. Fuel adjustment
Ook voor Dynojet Power Commander III: Installatie-instructies (4 pagina's), Installatie-instructies (3 pagina's), Installatie-instructies (4 pagina's), Installatie-instructies (5 pagina's), Installatie-instructies (5 pagina's), Installatie-instructies (3 pagina's), Installatie-instructies (3 pagina's), Installatie-instructies (4 pagina's), Installatie-instructies (3 pagina's), Installatie-instructies (3 pagina's), Installatie-instructies (5 pagina's), Installatie-instructies (3 pagina's), Installatie-instructies (3 pagina's), Installatie-instructies (3 pagina's), Installatie-instructies (3 pagina's), Installatie-instructies (3 pagina's), Installatie-instructies (3 pagina's), Installatie-instructies (3 pagina's), Installatie-instructie (5 pagina's), Installatie-instructies (4 pagina's)

Pagina afdrukken
Dynojet Power Commander III Installatie-instructies
Attach PCIII here
Rubber boot properly installed on ECM
Stock connector
Strap
i802-511
www.powercommander.com
7
8
9
10
PCIII connectors
11
12
13
Attach PC III module to battery
box. First, clean the PCIII and
battery box with the supplied
alcohol wipe. Using the supplied
velcro attach PCIII to the battery
box. Also secure the unit with
the included zip ties. If your
bike has cruise control, attach
the unit to the face of the cruise
control module (Fig. C).
Disconnect the large connector
from the ECU. Carefully
remove the rubber dust shield.
Install the dust shield onto the
matching connector on the
PCIII.
Plug the PCIII connectors in-line
of the stock ECM and wiring
harness (Fig. E). Make sure to
use the supplied rubber strap
over the connectors.
Use the supplied zip ties to
secure the connectors in place.
Tighten down the 7/16 nuts that
hold the ECM to the battery tray.
Reinstall bodywork.
99-01 Harley Davidson TC88 - PCIII USB - 3