AGS Merlin WTM Installatie- en bedieningsinstructies - Pagina 5

Blader online of download pdf Installatie- en bedieningsinstructies voor {categorie_naam} AGS Merlin WTM. AGS Merlin WTM 10 pagina's. Water temperature monitor

Pagina afdrukken

AGS WTM Installation, Operation & Maintenance

Circuit Board Terminals

Damage to PCBs when creating cable entry points may void any warranty!

Any damage attempting to remove the circuit board may void any warranty!

All Class 2 wiring is to be installed within flexible tubing to maintain segregation between circuits!

Wiring of different circuits shall be separated by means of routing, clamping or barrier!

A switch or circuit breaker must be fitted, it must be accessible and marked as the disconnecting device!

A disconnector is required for the 24V supply, and an adequate overcurrent device is fitted!

For field connections use wires suitable for at least 167°F (75°C)

Connecting both mains 120V~ and 24Vac/dc power is considered misuse – use only one power input!

Terminals are pluggable for ease of wiring and therefore subject to misplacement resulting in a hazardous

condition!

Power Inputs

The controller requires an AC power supply of 110/240VAC wired to the [POWER/LINE IN] connector using

a 3A switched fused spur.

Alternatively, the unit can be powered via the 24VAC [POWER IN] terminal. When power is introduced, a red

LED will illuminate on the front of the controller on the AGS Logo.

Rev 1 0223