GAM Flickermaster DMX 8 Gebruiksaanwijzing

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} GAM Flickermaster DMX 8. GAM Flickermaster DMX 8 2 pagina's. Dmx control

Pagina afdrukken

• DMX or Manual Control

• Available in 120 volt or 220 Volt Models

• Rugged Aluminum Case with Carry Handle

• Recessed Control Panels to Protect Knobs

and Circuit Breaker

• Up to 2000 Watt Capacity

For Best LED Results:

• Use 120 volt LED fixture or lamp that

does not require a transformer or power supply

For Best Fluorescent Results:

• If possible use dimmable ballasts for best results

• Excessive strobing or flickering may

shorten lamp life

OPERATION INSTRUCTIONS

Apply appropriate power to pigtail. Flickermaster

DMX8 © can be supplied with Edison plugs, stage pin,

twist lock connectors or bare wire. The 220V model

is supplied with bare leads - green is ground.

SELECT

OFF - Left hand knob in the OFF position, no output

from the Flickermaster DMX8 ©

DIM - Set left knob to DIM when you wish to use

Flickermaster DMX8 © as a dimmer, or when focusing

your lights so that they are not blinking or strobing.

Dimmer knob controls brightness and must be turned

up past zero for light to come on.

FLICKER - Set left knob to this position when a

random flicker is wanted. (SPEED, LOW and DIM

are operational in FLICKER and STROBE mode.)

STROBE - Set left knob to this position for STROBE effect.

SPEED

Use to adjust the rate of flicker or strobe - 0 is slow,

10 is the fastest. Speed setting is operational in

FLICKER or STROBE modes.

LOW LEVEL

Low level control allows for variable compression of the

flicker range to create the very low flickering of gas lamps

or a roaring fire. Functional when Flickermaster DMX8 © is

set to FLICKER or STROBE modes.

DIM

Dimmer control - 0 being lowest, 10 the highest. Func-

tional in all settings except OFF. You may use the dimmer

to compress the high level of the flicker or to fade out an

effect in either FLICKER or STROBE modes.

FLICKERMASTER DMX8

OPERATING INSTRUCTIONS

REMOTE JACK - Used to turn Flickermaster DMX8 ©

on and off from a remote location. See remote jack or

DMX instructions on back page.

STATUS (Green/Red LED) - When powered, this light

is red and green when DMX is present.

OUTPUT (Red LED) - Indicates level of output.

Flickers to show flicker/strobing range. In DIM setting,

glow intensity is relative to output level.

BACK PANEL

• Power IN / OUT pigtails, 20 amp.

• IN/OUT DMX & Channel Address

120V or 220V model.

Please see page 2 for Remote and DMX

Instructions

DIM FLICKER

OFF

STROBE

SELECT

STATUS

POWER

Page 1 of 2

INCANDESCENT • FLUORESCENT • LED

MAX LOAD OUTPUT 2000W

SPEED

LOW LEVEL

DIM

REMOTE