GAMA RF120V1PRDC Gebruiksaanwijzing - Pagina 2

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} GAMA RF120V1PRDC. GAMA RF120V1PRDC 2 pagina's. Rf receiver

GAMA Electronics, Inc.

P.O. Box 1488 Crystal Lake, IL 60039

Input/output Wiring:

Refer to the RF receiver terminal block nameplate when installing the AC input voltage and DC output to the winch. The

120 VAC Line is terminated to the "AC LINE IN', the 120 VAC input Neutral is terminated to the "AC IN NEUT"

terminal. Both green ground wires from the AC input to the receiver and winch should be connected with a wire nut.

The switch pendent on the winch must be disconnected from the cable. There are 4-wires of the cable that are terminated to

the switch pendent, these wires must be removed from the switch and installed on the receiver. The red wire from the

switch is terminated to the "DC IN POS" terminal. The black wire is terminated to the "DC IN NEG" terminal on the

receiver. The other two wires from the switch pendent are terminated to the "MOTOR 1" and "MOTOR 2" terminals on the

receiver.

Programming instructions:

Each keyfob transmitter has its own unique internal address that is transmitted whenever a button on the keyfob is pressed.

The receiver needs to be programmed to respond only to keyfob transmitters it is intended to operate with. The following

steps configure the receiver to operate with a keyfob transmitter(s). Up to twelve keyfob transmitters can be programmed to

one receiver. Please read the entire programming procedure before starting. Prior to programming the receiver, verify that

the receiver is connected to the input power. When the receiver enters program mode, all previous transmitter addresses that

were programmed will be erased from the receiver's memory.

Locate the pushbutton labeled "PROGRAM" on the receiver. Press and hold this button until the red LED next to

the program button illuminates (approximately 5 seconds). The receiver is now in the transmitter program mode.

Release the blue button. All previously programmed transmitter addresses are erased from the receiver's memory.

Press any switch on the keyfob transmitter and verify that the red LED on the receiver extinguishes and then

illuminates (blinks once). Release the button.

Within 5-seconds of Step 2, press a switch on the next transmitter to be programmed. The red LED on the receiver

will extinguish and illuminate one time for the first transmitter being programmed, twice for the second, three times

for the third, four times for the fourth etc. The receiver will not respond to transmitters that have already been

programmed.

After 5-seconds of no switch being pressed on the transmitter(s) the receiver will return to normal operation. The

red LED on the receiver will blink rapidly, then extinguish. The receiver is now in the normal mode of operation.

This completes the programming instructions. The receiver will retain all its programming even when power is

removed.

TEL: (815) 356-9600

WEB: www.gamainc.com

FAX: (815) 356-9603