GAMA RF120VPR1L Gebruiksaanwijzing - Pagina 3

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} GAMA RF120VPR1L. GAMA RF120VPR1L 3 pagina's. Rf receiver

GAMA Electronics, Inc.

P.O. Box 1488 Crystal Lake, IL 60039

Motor type 8:

Marathon / GE motors with terminals and colored wires:

Use blue wire nuts to connect the receiver to motor wires.

Motor terminal 1 to receiver T1, T3

Motor YELLOW and WHITE to receiver T2, T4

Motor RED to receiver T5

Motor terminal 2 to receiver T8

Motor type 9:

Leeson / Ace motors with terminals:

Motor terminal 1 to receiver T1, T3

Motor terminal 2 to receiver T2, T4

Motor terminal 5 to receiver T5

Motor terminal 3 to receiver T8

Motor type 10:

Emerson motors with terminals:

Motor terminal 3 to receiver T1, T3

Motor terminal 1 to receiver T2, T4

Motor terminal 4 to receiver T5

Motor terminal 2 to receiver T8

Momentary or Latching Output: The transmitter and receiver can be configured for momentary or latching operation. For

momentary operation, the output of the receiver will be active for as long as the transmitter switch is depressed and will turn

off when the switch is released. In the latching configuration, the receiver output will turn on as soon as the transmitter

switch is depressed and released. To turn off the latching output, the transmitter switch must be depressed and released

again.

Locate the pushbutton switch labeled "PROGRAM" on the receiver. Press and hold this switch until the red LED

next to the program switch illuminates (approximately 3 seconds). The receiver is now in the transmitter program

mode, release the switch. At this point all previously programmed transmitter addresses are erased from the

receiver's memory.

For momentary operation, press and release a switch on the transmitter. The red program LED on the receiver will

blink once. For latching output, press and release the same switch a second time, the program LED will flash on

and off.

Repeat previous step for additional transmitters that you desire the receiver to respond to. 4. The receiver will

return to normal mode if no transmitter switches are pressed for 5-seconds. The red LED on the receiver will flash

and then turn off. The receiver is now in the normal mode of operation. This completes the programming

instructions. The receiver will retain all of its programming even when power is removed.

TEL: (815) 356-9600

WEB: www.gamainc.com

FAX: (815) 356-9603