Hikmicro HM-TD2H67T-6/X Snelstarthandleiding - Pagina 3

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Hikmicro HM-TD2H67T-6/X. Hikmicro HM-TD2H67T-6/X 9 pagina's. Heat resistant bullet camera

Pagina afdrukken

Table 2-2 Description of Device

No.

Description

Alarm Input/Output

RS-232 Cable

RS-485 Cable

CVBS Cable

RJ45 Network Cable

Power Cable

3 Installation

3.1 Wiring

Please fully take into consideration the installation environment

and position of the device when you plan for the wiring. In order

to make sure the stable power supply and signal transmission,

please closely follow the rules below:



Confirm the installation environment before wiring,

including the wiring distance, wiring environment,

magnetic-field interference, etc.



The rated voltage of the wire should be higher than that the

device requires, so the device can work normally when the

voltage instability occurs.



It's recommended to use a single complete cable for wiring;

if not, reinforcement measures should be taken to protect

Heat Resistant Bullet Camera · Quick Start Guide

the wiring point between two cables, or the device may

work abnormally due to the circuit aging.



Make sure the device cables are well protected, and take

reinforcement and protective measures during wiring.



Avoid bumping the cables and damaging the magnetic ring,

or the device may work abnormally.



Make sure the cables are not too redundant or stretched too

tight.



The wiring should be completed by professional technicians.

When the device cannot work normally, you can check the

above information for troubleshooting.

3.2 Install the Camera

Before you start:

The bracket is not included in the package. Please purchase it

separately.

Steps:

1. Drill four holes on the wall according to the dimension of the

wall mounting bracket template.

Figure 3-1 Drill Holes on Wall

2. Drill four M8 screws into the holes.

Figure 3-2 Drill M8 Screws into Holes

3. Loosen and remove the screws to dissemble the PT joint.

Figure 3-3 Dissemble PT Joint

Note: ①: PT Joint Bottom; ②: PT Joint Top

4. Align the four holes on the bracket with the four M8 screws

on the wall, install the bracket on the wall, and tighten the

screws.