CORBERO FM850S/6 Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} CORBERO FM850S/6. CORBERO FM850S/6 12 pagina's.

Pagina afdrukken

1. Remove the plug from

the power socket.

2. Tilt back the appliance

carefully so that the com-

pressor cannot touch the

floor.

3. Unscrew both adjusta-

ble feet.

4. Unscrew the screws of

the door bottom hinge.

Remove the hinge. Put

over the pin in the direc-

tion of the arrow.

5. Unscrew and install the

screw on the opposite

side.

6. Install the hinge on the

opposite side.

7. Screw both adjustable

feet.

1) If foreseen

Do a final check to make sure that:

• All screws are tightened.

• The door opens and closes correctly.

If the ambient temperature is cold (i.e. in Winter), the

gasket may not fit perfectly to the cabinet. In that case,

wait for the natural fitting of the gasket.

In case you do not want to carry out the above men-

tioned operations, contact the nearest After Sales Serv-

ice Force. The After Sales Service specialist will carry

out the reversibility of the doors at your cost.

Electrical connection

Before plugging in, ensure that the voltage and fre-

quency shown on the rating plate correspond to your

domestic power supply.

8. Unscrew both screws

on the rear side.

9. Push back the top and

lift it from the fixing ele-

ments.

10. Unscrew the screws of

the door top hinge.

11. Remove the hinge.

Put over the pin in the di-

rection of the arrow. Install

the hinge on the opposite

side.

12. Tighten the hinge.

13. Put the top in position.

14. Pull it forward.

15. Screw both screws on

the rear side.

The appliance must be earthed. The power supply ca-

ble plug is provided with a contact for this purpose. If

the domestic power supply socket is not earthed, con-

nect the appliance to a separate earth in compliance

with current regulations, consulting a qualified electri-

cian.

The manufacturer declines all responsibility if the

above safety precautions are not observed.

This appliance complies with the E.E.C. Directives.

16. Remove and install

the handle

on the oppo-

site side.

17. Reposition, level the

appliance, wait for at least

four hours and then con-

nect it to the power socket.