Dynojet Power commander FC Handleiding voor installatie-instructies - Pagina 2

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Dynojet Power commander FC. Dynojet Power commander FC 6 pagina's. 2018 kawasaki klx250s fuel controller
Ook voor Dynojet Power commander FC: Installatie-instructies (4 pagina's)

Pagina afdrukken
STATUS Light
MAP Select
LOW RPM Dial
MID RPM Dial
HIGH RPM Dial
Position
Note
2009-2015 Yamaha XV950
Position 1
Stock exhaust
Stock air filter
2014-2017 Yamaha Bolt 950 & SCR950
Position 2
Stock exhaust
Stock air filter
IFC22035
www.powercommander.com
SELECTING THE MAP POSITION
The Dynojet Power Commander Fuel Controller (PCFC) comes loaded with up to ten
maps. Using a #1 Phillips screwdriver, turn the map select dial to toggle between the
loaded maps. Refer to the map position table for the maps included in your PCFC.

USING THE RPM RANGE DIALS

The Low, Mid, and High RPM Dials refer to the RPM range, in thirds, of your vehicle.
Each dial allows +/- 10% fuel adjustment on top of what fuel changes are done in the
map. With the dial facing straight up, there is no additional fuel change.
For example, if your vehicle revs to 6000 RPM:
• The low RPM dial will adjust 0-2000 RPM
• The mid RPM dial will adjust 2001-4000 RPM
• The high RPM dial will adjust 4001-6000 RPM

USING PCFC CONTROL CENTER

USB Port
Take your tuning to the next level with the PCFC Control Center software.
1
Using your web browser, navigate to www.powercommander.com.
2
Click Enter Race Ready.
3
Click Downloads.
4
Click Access Downloads for Power Commander FC.
5
Click the PCFC software Download button.
6
Open the zip folder.
7
Double-click the install file and follow the on-screen instructions to install the PCFC
Control Center software. The PCFC Control Center software and maps will be
stored in C:\Program Files\PCFC Control Center.
8
Return to the Downloads or Home page where you can enter the make, model, and
year of your bike to check for and download additional maps.
LOADING ADDITIONAL MAPS
1
Connect the USB cable from the computer to the PCFC. Verify the cable is fully
seated in the PCFC.
2
Run the Control Center software by double-clicking the program icon installed on
your desktop or on your start menu.
3
Click Open Map File and select a map file.
4
Click Send Map. You can send the map to any of the ten map positions.
ALTERING MAPS USING SOFTWARE
The values in the map represent a percentage of fuel change over stock. A value of 10 in
the map indicates at that throttle position and RPM range the vehicle will be 10% richer
than stock. If the value is -10, then it would be 10% leaner than stock. You have the
ability to fine tune your fuel curve by altering these values. The Control Center software
allows a value of +250 to -100 in each cell.
2009-2017Yamaha XV950, Bolt 950, & SCR950 - 2