AGS Merlin 1000S Gebruikers- en installatiehandleiding - Pagina 5

Blader online of download pdf Gebruikers- en installatiehandleiding voor {categorie_naam} AGS Merlin 1000S. AGS Merlin 1000S 10 pagina's. Gas utility isolation controller
Ook voor AGS Merlin 1000S: Installatie-, Bedienings- en Onderhoudshandleiding (10 pagina's), Installatie- en bedieningshandleiding (12 pagina's), Installatie- en bedieningshandleiding (16 pagina's)

Merlin 1000S

(7)

[FS1/2/3/4]

Fan Switch Output

This terminal switches when the key is turned on and off. This can be linked to a fan switch

(panel supplied separately) which can provide power to fans when the control panel is

switched on.

(8)

[CO2 MONITOR]

Monitor

This terminal can be wired to CO

system in the event of High CO2 levels.

If no CO

monitor is supplied leave the terminal link in [

(fig3)

(9)

[12VDC]

This is a permanent 12v DC output when there is power at

the panel and can be used to create a relay switch with the

BMS relay output. Please contact your supplier for further information.

Use a screened cable to avoid electrical interference between HIGH & LOW VOLTAGE connections

Operates at 65dB measured 30cm from closed panel.

The Merlin 1000S has a built-in Auto-shut down feature and it will turn itself off after a

predefined time. Auto-shut down timeout is selectable.

There are two Dip-Switches located on the inside facia of the Merlin 1000S labelled [Time1]

and [Time2]. (fig4) The gas supply will be cut off at desired time-out.

To select required timeout – configure Dip Switches as follows;

2 HOURS (FACTORY SET)

Time1 Off / Time2 Off

4 HOURS

Time1 On / Time2 Off

8 HOURS

Time1 Off / Time2 On

NO TIMEOUT

Time1 On / Time2 On (auto-shut down disabled)

Rev: 04 Date: 15-08-18

Gas Utility Controller

monitor to shut off the

User & Installation Manual

fig3

fig4