KitchenAid Architect Series II KSCS23FV Specificaties
Blader online of download pdf Specificaties voor {categorie_naam} KitchenAid Architect Series II KSCS23FV. KitchenAid Architect Series II KSCS23FV 1 pagina's. Kitchenaid architect series ii kscs23fv: specifications
Ook voor KitchenAid Architect Series II KSCS23FV: Dimension Handleiding (1 pagina's)
Pagina afdrukken
PRODUCT MODEL NUMBERS
KSCS23FT
KSCS23FV
KSCS25FT
KSCK23FV
KSCS25FV
KSCK25FV
Electrical: A 115-volt, 60-Hz, AC-only 15- or
20-amp fused, grounded electrical supply is
required. It is recommended that a separate circuit
serving only your refrigerator be provided. Use an
outlet that cannot be turned off by a switch. Do not
use an extension cord.
Water Supply: A cold water supply with water
pressure of between 30 and 120 psi (207 and
827 kPa) is required to operate the water dispenser
and ice maker.
IMPORTANT: The pressure of the water supply
coming out of a reverse osmosis system going to
the water inlet valve of the refrigerator needs to be
between 30 and 120 psi (207 to 827 kPa).
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to be
a minimum of 40 to 60 psi (276 to 414 kPa).
The cabinet depth refrigerator can be installed into
a recessed opening, at the end of cabinets or as a
freestanding refrigerator.
Do not install the refrigerator near an oven, radiator,
or other heat source, nor in a location where the
temperature will fall below 55°F.
CABINET OPENING DIMENSIONS
■ Height dimensions are shown with the leveling legs extended to
the minimum height of 1/4" (6.35 mm) below the refrigerator.
NOTE: When leveling legs are fully extended to 1" (25 mm)
below the refrigerator, add 3/4" (19 mm) to the height
dimensions.
■ Minimum fixed wall position is 13-1/4" (34 cm) from the freezer
door and 16-1/2" (42 cm) from the refrigerator door.
36"
(91.5 cm)
¹⁄₄
13
"
(34 cm)
A
Height "A"
Model size
Standard Cabinet
23 cu.ft. (654 L)
69" (175.3 cm)
25 cu.ft. (694 L)
72" (182.9 cm)
*For full-overlay cabinet doors with a trim kit, the opening height
must be adjusted as shown.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
®
Counter Depth, Side by Side Refrigerator
PRODUCT DIMENSIONS
Top View
15 "
(39.6 cm)
Front View
Model Size
23' (654 L)
25' (694 L)
¹⁄₂
16
"
(42 cm)
DOOR SWING DIMENSIONS
³⁄₄
41
"
(106 cm)
Height "A"
Full-overlay*
69-1/8" (175.6 cm)
72-1/8" (183.2 cm)
"
(95.3 mm)
35 "
(90.5 cm)
24"
(61.0 cm)
27 "
(69.7 cm)
19 "
(49.5 cm)
2 "
(6.7 cm) max.
A. Dimensions may vary based on the model
A
35
"
(90.6 cm)
3 "
(9.2 cm)
Height A
64 " (164.8 cm)
67 " (172.1 cm)
⁵⁄₈
13
"
(34.5 cm)
⁵⁄₈
2
"
(6.6 cm)
¹⁄₂
"
(12.7 mm)
90˚
150˚
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
■ Height dimensions are shown with the
leveling legs extended to the minimum
height of 1/4" (6.35 mm) below the
refrigerator.
When leveling legs are fully extended to
1" (25 mm) below the refrigerator, add 3/4"
30 "
(19 mm) to the height dimensions.
(76.4 cm) max.
■ The power cord is 66" (167.7 cm) long.
■ The water line attached to the back of the
refrigerator is 78" (198.1 cm) long.
A
A
A
B
B
3 " (9.2 cm)
3 " (9.2 cm)
Model Size
A
23'
68 "
(654 L)
(174.6 cm)
25'
71 "
(694 L)
(182.2 cm)
When leveling legs are fully extended to 1" (25 mm) below the
refrigerator, add
" (19 mm) to the height dimensions.
17"
(43.0 cm)
Location must permit doors to open to a
minimum of 150°. Allow 13-1/4" (34 cm)
minimum space between the side wall
¹⁄₂
0"
45
"
and the freezer side of the refrigerator.
(0.1 mm)
(115.6 cm)
Allow 16-1/2" (42 cm) minimum space
between the side wall and the
refrigerator side.
NOTE: Dimensions may vary based on
model.
Side View
"
"
21
21
(54.1 cm)
(54.1 cm)
66"
66"
(167.7 cm)
(167.7 cm)
C
C
B
C
68 "
68 "
(175.0 cm)
(174.0 cm)
71 "
71 "
(182.5 cm)
(181.6 cm)
Ref. 2318510B
09-18-08