Gama Sonic Denali 229iM60012 Gebruiksaanwijzing - Pagina 3
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Gama Sonic Denali 229iM60012. Gama Sonic Denali 229iM60012 4 pagina's. Commercial solar led post light with morph technology
Pagina afdrukken
Assembly Instructions
SINGLE LAMP HEAD
•
Secure the threaded rod (C) to the lamp head (B) by
screwing it in clockwise and tighten with a wrench. (Do
not overtighten).
•
Remove the screw cap, nut, and lock washer from the
threaded rod (C).
•
Slide the rod cover (D) over the threaded rod (C).
•
Slide the threaded rod through the hole in the arm
assembly (A) and secure using the nut.
NOTE: The nut needs to fit into the relief cut of the
arm assembly. Once in there, spin the lamp head (B)
clockwise until the lamp head is securely fastened to
the arm assembly (A).
•
Place the lock washer and cap
nut on top of the threaded rod
and tighten.
•
Place the arm assembly (A) over a
3" pole and secure by tightening
the four set screws.
•
Follow the Operation Instructions
to turn the lamp on.
DOUBLE LAMP HEAD
(requires purchase of an additional lamp)
•
Remove the four screws holding the cap on to the top
of both arm assemblies (A).
•
On one of the assemblies, remove the bolt and lock
washer from the inside using an open end or socket
wrench.
•
Also remove the cap nut and lock washer on the
outside and separate the arm from the center support.
•
On the other assembly, remove the plug at the top
from the inside by pushing it out.
•
Remove the cap nut and spacer piece.
•
Install the arm removed form the first assembly onto
the center support of the second one and secure from
the outside using the lock washer and cap nut.
•
Secure from the inside using the lock washer and bolt
and tighten with a wrench.
•
Reinstall the cap with the four screws on top of the arm
assembly (A).
•
Install the lamp heads utilizing the instructions above
for "SINGLE LAMP HEAD" and repeat for both sides.
page 3
Operation Instructions
(follow these instructions for each lamp head)
Turning the lamp on
•
Remove the cover over the LED's by twisting counter
clockwise.
•
Move the operation switch to one of the options below
based on your desired performance:
- Low = Softer light, longer duration
- High = brighter light output
Timer Switch
•
Using a small flathead screwdriver, turn the arrow to
one of the following settings:
- 0 = Dusk to Dawn operation
- 4,5,6,7,8 = The number of hours the lamp will
operate from Dusk.
•
If a number other than 0 is selected, the lamp will
operate for that many hours from dusk and will then
turn off for the remainder of the night.
•
Re-attach the cover and twist clockwise to secure.
•
Your lamp will operate automatically at dusk.
Replacement Parts
Replacement Batteries are available at
www.gamasonic.com or via our Toll Free
number: +1-800-835-4113.
Your lamp uses two of the following battery:
GS32V12A