Gama Sonic GS-94FPW-PIR Handmatig - Pagina 5

Blader online of download pdf Handmatig voor {categorie_naam} Gama Sonic GS-94FPW-PIR. Gama Sonic GS-94FPW-PIR 6 pagina's. Solar lamp post with motion sensor

Pagina afdrukken
Gama Sonic GS-94FPW-PIR Handmatig
Fig. 5
GS-94FPW-PIR Pier mount
1. Use an electric drill to make two holes in the desired surface. Place provided anchors (D) into
holes, place the base (B) in line with the holes and screw the provided screws (C).
2. Screw part (A) into Part (B) and turn the On/Off switch in the lamp head (A) to ON or PIR
position according (Fig. 1).
GS-94NW-PIR Wall mount
NOTE: Install your solar lamp facing the south for best results.
1. Use an electric drill to make two holes in the wall, place provided anchors (D) into holes,
place the wall bracket (B) in line with the holes and screw the provided screws (C).
2. Screw part (A) into Part (B) and turn the On/Off switch in the lamp head (A) to ON or PIR
position according (Fig. 1).
GS-94NF-PIR 3" Fitter
NOTE: If you are replacing an existing gas/electric post light, you must consult a certified technician to
cancel them before installation.
1. Screw Part (B) on top of the existing 3" post using the screws provided.
2. Screw Part (A) into Part (B) and turn the On/Off switch in the lamp head (A) to ON or PIR
position according (Fig. 1).
Replacing the Batteries
(After several years of use, the batteries may need replacing).
1. Detach the top of the lamp unit (A)
by releasing the 2 screws (Fig. 1).
2. Make sure the ON/OFF switch is in the "OFF" position.
3. Release the 3 screws on the silver reflector and remove
the old batteries. Make sure the new batteries are
high quality –1 x Li-ion rechargeable Battery Pack
(3.2 Volt / 3,000 mAh) (Fig. 5).
4. Install the new batteries into the battery compartment.
5. Reassemble the unit by reversing the above procedure.