Corbin Russwin Access 800 Programmeerinstructie - Pagina 3
Blader online of download pdf Programmeerinstructie voor {categorie_naam} Corbin Russwin Access 800. Corbin Russwin Access 800 16 pagina's. Cl33800 tcac2 series cylindrical lockset
Ook voor Corbin Russwin Access 800: Handleiding voor installatie-instructies (17 pagina's), Handleiding voor installatie-instructies (16 pagina's)
Pagina afdrukken
Access 800
Series
™
Locks
Keypad Programming Instructions
2
General Programming
To Begin Programming:
The Lock Controller is preset at the factory with
Master Code "1234". It is strongly recommended
that the Master Code be changed as the first
programming step. Entering 1234 * will unlock
the lock allowing the lever handle to retract the
latchbolt.
Initial Set-Up Procedures:
•
The following are typical procedures to be used
when setting up your Access 800 lock.
•
If a mistake is made during any of procedures,
depress the "*" key several times until the
yellow LED goes out.
•
If no keystroke is made in a 30 second time
frame, the programming up to that point will
default and you will have to start over.
3
Individual Door Log Sheet for Keypad Programming
Lock Model: _______________________________
Door Name: ________________________________
Location: __________________________________
Function
Master Code
Supervisor Code
*Note: If memory is cleared, you must reprogram Emergency code. The Master code resets
back to 1234*.
User Name
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
Copyright © 2018-2019 Corbin Russwin, Inc., an ASSA ABLOY Group
company. All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
Main Codes - User Programmed "Door" Log
User Location
Default Code
01
02
User Programmed "Door" Log
User Type
User Location
3
Determine which programming steps to use
for your lock:
•
If your label has an M800, then use the
programming in Section 4. (Figure 1)
•
If your label has an M801, M803, M804, or
M806, reference programming in Section 5.
(Figure 2)
•
If your label has a M802 or M805,
Accessware™ application Software must
be used for programming. See Section 7.
(Figure 2)
M800
Grey Button
Figure 1
User Programmed Code
1234&
User Code
M80X
White Button
Figure 2
Card/Fob#, Notes
(617417440) FM359 7/19