HIKOKI SB3608DA Handling Instructies Handleiding - Pagina 12

Blader online of download pdf Handling Instructies Handleiding voor {categorie_naam} HIKOKI SB3608DA. HIKOKI SB3608DA 20 pagina's.

Pagina afdrukken

Charger

Status of indicator

status

lamp

ON/OFF at 0.5 sec.

Before

intervals (RED)

charging

Lights for 0.5 sec.

at intervals of 1 sec.

(BLUE)

Lights for 1 sec. at

While

intervals of 0.5 sec.

charging

(BLUE)

Lights continuously

(BLUE)

Lights continuously

(GREEN)

Charging

complete

(Continuous buzzer

sound: about 6 sec.)

ON/OFF at 0.3 sec.

Overheat

intervals (RED)

standby

ON/OFF at 0.1 sec.

intervals (PURPLE)

Charging

impossible

(Intermittent buzzer

sound; about 2 sec.)

*1 If the red lamp continues to blink even after the charger

has been attached, check to conﬁ rm that the battery has

been fully inserted.

*2 Although charging will start once the battery has cooled

down even when left in situ, the best practice is to

remove the battery and allow it to cool down in a shaded,

well-ventilated location before charging.

○ Fully insert the battery.

○ Check to conﬁ rm that no foreign matter is stuck to the

battery mount or terminals.

○ Charging will take longer at extremely low ambient

temperatures. Charge the battery in a warm location

(such as indoors).

○ Do not block the air vent. Otherwise the interior will

overheat, reducing the charger's performance.

○ If the cooling fan is not operating, contact a HiKOKI

Authorized Service Center for repairs.

Table 1

Indication meaning

Plugged into power

source *

Charged at less than

50%

Charged at less than

80%

Charged at more

than 80%

Battery overheated.

Unable to charge. *

Malfunction in

the battery or the

charger *

(2) Regarding the temperatures and charging time of the

rechargeable battery

The temperatures and charging time will become as

shown in Table 2.

Model

Type of battery

Charging voltage

Temperatures at which the battery

can be recharged

Charging time for

battery capacity,

approx.

(At 20°C)

Multi

volt

battery

Number of battery cells

Charging voltage for USB

Charging current for USB

Weight

NOTE

The recharging time may vary according to the ambient

temperature and power source voltage.

CAUTION

When the battery charger has been continuously used,

the battery charger will be heated, thus constituting

the cause of the failures. Once the charging has been

completed, give 15 minutes rest until the next charging.

4. Disconnect the charger's power cord from the

receptacle.

5. Hold the charger ﬁ rmly and pull out the battery.

NOTE

Be sure to pull out the battery from the charger after use,

and then keep it.

Regarding electric discharge in case of new batteries,

etc.

As the internal chemical substance of new batteries and

batteries that have not been used for an extended period

is not activated, the electric discharge might be low when

using them the ﬁ rst and second time. This is a temporary

phenomenon, and normal time required for recharging

will be restored by recharging the batteries 2–3 times.

Table 2

UC18YSL3

14.4–18 V

0°C–50°C

1.5 Ah

15 min

2.0 Ah

20 min

2.5 Ah

25 min

20 min

3.0 Ah

(BSL1430C,

BSL1830C: 30 min)

26 min

4.0 Ah

(BSL1840M: 40 min)

5.0 Ah

32 min

6.0 Ah

38 min

8.0 Ah

52 min

1.5 Ah (× 2 unit)

20 min

2.5 Ah (× 2 unit)

32 min

4.0 Ah (× 2 unit)

52 min

Li-ion

4–10

5 V

2 A

0.6 kg