JADO Borma 814 098 Series Installatie-instructies - Pagina 2

Blader online of download pdf Installatie-instructies voor {categorie_naam} JADO Borma 814 098 Series. JADO Borma 814 098 Series 2 pagina's. Personal hand shower with adjustable wall mounted bar

Pagina afdrukken
TOOLS REQUIRED
Adjustable Wrench
Teflon Tape
ROUGHING-IN
DIMENSIONS
3-3/4"
(48" - 60") (OPTIONAL)
TO FINISHED FLOOR
23-5/8"
FINISHED
WALL
1
Turn off hot and cold water
CAUTION
INSTALL WALL SUPPLY
supplies before beginning.
Supply to WALL SUPPLY (1) is 1/2" NPT. See rough-in above for detailed information.
Install RUBBER SEAL (2) onto WALL SUPPLY (1).
Apply sealant or teflon tape to threads of 1/2" NPT supply nipple. Thread WALL SUPPLY (1)
onto supply nipple making a water tight seal. WALL SUPPLY (1) with RUBBER SEAL (2)
should be tight against finished wall.
Phillips Screwdriver
Plumbers' Putty or Caulking
Regular Screwdriver
1-1/16"
(1/2)
WALL SUPPLY
WITH BUILT IN
BACK FLOW
1/2
PREVENTER
N.P.T.
1/2 NPSM HOSE
CONNECTION
RUBBER GASKET
FINISHED
WALL
1-1/8" D.
7-5/8"
59"
2
1
1/2" NPT
APPLY SEALANT
2
INSTALL WALL BRACKETS
The ADJUSTABLE SHOWER BAR (1) works best if secured to a wall stud or cross brace within the wall, using the SCREWS (2) supplied.
If the ADJUSTABLE SHOWER BAR (1) is to be installed on a tile or plaster wall the ANCHORS (3) and SCREWS (2) should be used.
Determine desired height and location (optional) and mark a center line. If MOUNTING SUPPORT (4) is secured to a stud or cross brace
drill small pilot holes for SCREWS (2).
For installations on drywall or tiled walls: Use ANCHORS (3) and SCREWS (2) for securing MOUNTING SUPPORT (4) to finished wall.
Drill a 1/4" dia. hole a minimum of 1-3/4" deep. Insert the the ANCHORS (3) flush with face of the finished wall.
Install RUBBER WASHER (5) in recess of MOUNTING SUPPORT (4). Secure MOUNTING SUPPORT (4) to wall with SCREWS (2).
3
INSTALL ADJUSTABLE SHOWER BAR
Install ADJUSTABLE SHOWER BAR (1) onto installed MOUNTING SUPPORTS (4).
Push ADJUSTABLE SHOWER BAR (1) flush against finished wall and tighten
SET SCREWS (5) with (2.5mm) HEX WRENCH (7) supplied to secure
ADJUSTABLE SHOWER BAR (1) to wall.
10
8
9
4
INSTALL HOSE AND HAND SHOWER
Install SEAL (8) into COUPLING NUT (9). Connect COUPLING NUT (9) to WALL SUPPLY NIPPLE (10) and tighten.
INSTALL second SEAL (11) into SPRAY HOSE END (12 ) and connect HAND SHOWER (13) to SPRAY HOSE END (12).
Hand tighten.
1 0 9 6 4 4
2
5
FINISHED WALL
13
7
2
11
1
12
23-5/8"
FROM CENTER TO
CENTER OF WALL
BRACKETS
3
5
4
C/L
RECESS IN
MOUNTING
SUPPORT
23-5/8"
4
5
3`
C/L
1 0 9 6 4 4