Deaf Bonce MACHETE MMA-1100.1D Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Deaf Bonce MACHETE MMA-1100.1D. Deaf Bonce MACHETE MMA-1100.1D 20 pagina's. Mono amplifiers class d

Pagina afdrukken

4. SELECTION OF THE DIAMETER OF POWER CABLES AND SPEAKER CABLES

S e l e c t i o n o f t h e d i a m e t e r o f t h e p o w e r c a b l e s

Use the table below to select the desired diameter based

on the length and the current consumption.

5 . W I R I N G D I A G R A M S

Connect the speaker cables from the positive and negative terminals of the speakers to the respective outputs of the ampliﬁer

terminal marked with SPEAKER OUTPUT, as shown at the diagram. To connect the power wire supply it is necessary to use special

power cables. The fuse is placed in the holder and ﬁxed in the cable cut. One end of the cable is connected to the positive terminal

of the battery, the second one – to the ampliﬁer terminals marked with + 12V. Be sure to use a fuse with the parameters suﬃcient

for use in the system. The length and diameter of the grounding cable must conform to the length and diameter of the cable +

12V. Connect one end to the negative terminal of the battery and the other end of the grounding cable to the terminals marked

with GND. Connect the head unit (HU) to low-level inputs of the ampliﬁer using RCA cable.

Standard wiring diagram of mono amplifier to one subwoofer and

Step 1. Connect the speaker cable from (+) terminal of the ampliﬁer to (+) terminal of the speaker.

Step 2. Connect the speaker cable from (-) terminal of the ampliﬁer to (-) terminal of the speaker.

Step 3. Connect one end of the power cable from (+) terminal of the battery and the second end to the ampliﬁer terminal marked

with + 12V. Do not forget to protect positive power cable with appropriate fuse.

Step 4. Connect one end of the power cable from (-) terminal of the battery and the second end of the grounding cable to the

terminals marked with GND.

Step 5. Connect one end of the cable to the Remote output terminal at the HU and the second end to the ampliﬁer terminal marked

with REM.

Caution!!! The minimum permissible connection load impedance is 1 ohm.

For models MMA-550.1D, MMA-1100.1D the operating voltage is 9-15 V.

S e l e c t i o n o f t h e d i a m e t e r o f t h e s p e a k e r c a b l e s

Use the table below to select the desired diameter based

on the length and the power consumption.

to battery.