GAMCO BCS-1 Installatie- en bedieningsinstructies - Pagina 2

Blader online of download pdf Installatie- en bedieningsinstructies voor {categorie_naam} GAMCO BCS-1. GAMCO BCS-1 2 pagina's. Wall-mounted
Ook voor GAMCO BCS-1: Montage-, installatie- en bedieningsinstructies (2 pagina's)

Pagina afdrukken

INSTALLATION INSTRUCTIONS

HORIZONTAL BABY CHANGING STATION

GAMCO WALL-MOUNTED BCS-1 AND BCS-2

Step 1.

Remove changing station from the shipping container and check for any freight damage. Identify the

best location for installing the unit. Hold the unit in place and open the bed. Make sure you have taken

the operating clearance into consideration.

Step 2.

Based upon the type of wall on which you will be mounting the station, determine the best method of

mounting. You may have left over hardware when you are fi nished with installation.

Step 3.

The horizontal unit has four mounting holes provided in the back wall of the unit. The four holes are

positioned on a 32" (813mm) stud center.

If possible, locate the wood or metal studs for fastening the changing station in the desired location.

If the walls do not have studs on center as outlined, make sure at least one side of the unit is installed

into the stud. Use toggles (may have to purchase) for holes on the other side.

Step 4.

Find the stud where you will be attaching the left side of the changing station to the wall. Measure up

from the ﬂ oor 44" (1118mm), at the center of the stud and mark the wall. Mark holes using a level and

measuring tape to make sure holes are precisely positioned. Hold unit in place to check. Use a 1/8"

drill bit to make pilot holes and the four ¼" x 3" panhead screws with washers (supplied) to attach the

unit to the wall studs. This will place the bottom of the station 26-1/2" (673mm) from the ﬂ oor and the

top of the bed at 33" (838mm) from the ﬂ oor.

If the wall surface is masonry or tile over wood studs, use a 7/32" masonry drill bit for the pilot hole

until you hit the stud. Change bit to 1/8" regular drill bit. Use the four 1/4" x 3" panhead wood screws

with washers (supplied).

If the wall has wood studs that are not on

32" (813mm) centers, has metal studs or an

underlying surface of concrete block, drill with

a 1/2" (12mm) masonry bit. (You may have

to purchase toggles before installing.) You

must allow a minimum of inside wall space for

toggles to turn depending on toggles used.

Insert and tighten toggles.

Bobrick Customer Service New York Division

Phone: (518) 877-7444 • Fax: 518-877-5029

Bobrick Customer Service Los Angeles Division

Phone: (818) 982-9600 • Fax: 818-503-9287

or email [email protected]

Gamco Commercial Restroom Accessories: A Division of Bobrick, One Gamco Place, Durant, OK 74701-1910

For Customer Service Bobrick New York Division Phone: (518) 877-7444 • Fax: 518-877-5029

For Customer Service Bobrick Los Angeles Division Phone: (818) 982-9600 • Fax: 818-503-9287

P/N 1027

Issued 8/2012

Printed in U.S.A.