HIKOKI C 18DBAL Handling Instructies Handleiding - Pagina 8
Blader online of download pdf Handling Instructies Handleiding voor {categorie_naam} HIKOKI C 18DBAL. HIKOKI C 18DBAL 20 pagina's.
Pagina afdrukken
Before
charging
While
charging
Charge
indicator
lamp
(red / blue
/ green /
Charging
purple)
complete
Overheat
standby
Charging
impossible
NOTE: When standby for cooling battery, UC18YSL3 cools the overheated battery by cooling fan.
● Regarding the temperatures and charging time of the
battery.
The temperatures and charging time will become as
shown in Table 2.
Battery
Charging voltage
Weight
Temperatures at which the
battery can be recharged
Charging time for battery
capacity, approx. (At 20oC)
BSL14xx series, BSL18xx series
1.5 Ah
2.0 Ah
2.5 Ah
3.0 Ah
(BSL1430C, BSL1830C)
3.0 Ah
4.0 Ah
5.0 Ah
6.0 Ah
Multi volt series
BSL36A18
BSL36B18
Number of battery cells
NOTE
The recharging time may vary according to the ambient
temperature and power source voltage.
CAUTION
When the battery charger has been continuously used,
the battery charger will be heated, thus constituting
the cause of the failures. Once the charging has been
completed, give 15 minutes rest until the next charging.
Indications of the charge indicator lamp
Lights for 0.5 seconds. Does not light for 0.5
Blinks
seconds. (off for 0.5 seconds)
(red)
Lights for 0.5 seconds. Does not light for 1
Blinks
second. (off for 1 second)
(blue)
Lights for 1 second. Does not light
Blinks
for 0.5 seconds. (off for 0.5 seconds)
(blue)
Lights
Lights continuously
(blue)
Lights continuously
Lights
(green)
(Continuous buzzer sound: about 6 seconds)
Lights for 0.3 seconds. Does not light for 0.3
Blinks
seconds. (off for 0.3 seconds)
(red)
Lights for 0.1 seconds. Does not light for 0.1
Flickers
seconds. (off for 0.1 seconds)
(purple)
(Intermittent buzzer sound: about 2 seconds)
Table 2
Charger
UC18YFSL UC18YSL3
V
14.4 – 18
kg
0.5
0oC – 50oC -10oC – 50oC
min.
22
min.
30
min.
35
min.
45
min.
45
min.
60
min.
75
min.
90
min.
75
min.
120
4 – 10
Table 1-b
4. Disconnect the charger's power cord from the
receptacle.
5. Hold the charger fi rmly and pull out the battery.
NOTE
Be sure to pull out the battery from the charger after use,
and then keep it.
CAUTION
○ If the battery is charged while it is heated because it has
been left for a long time in a location subject to direct
sunlight or because the battery has just been used, the
pilot lamp of UC18YFSL charger lights for 1 second,
0.6
does not light for 0.5 seconds (off for 0.5 seconds), or
the charge indicator lamp of UC18YSL3 charger lights
for 0.3 seconds, does not light for 0.3 seconds (off for 0.3
seconds). In such a case, fi rst let the battery cool, then
start charging.
○ When the pilot lamp or charge indicator lamp fl ickers (at
0.2-second intervals), check for and take out any foreign
objects in the charger's battery connector. If there are no
15
foreign objects, it is probable that the battery or charger
20
is malfunctioning. Take it to your authorized Service
25
Center.
30
○ Since the built-in micro computer takes about 3 seconds to
confi rm that the battery being charged with charger is taken
20
out, wait for a minimum of 3 seconds before reinserting it
26
to continue charging. If the battery is reinserted within 3
32
seconds, the battery may not be properly charged.
38
○ If the pilot lamp or charge indicator lamp does not blink
in red (every second) even though the charger cord is
connected to the power, it indicates that the protection
32
circuit of the charger may be activated.
52
Remove the cord from the power and then connect
it again after 30 seconds or so. If this does not cause
the pilot lamp or charge indicator lamp to blink in red
(every second), please take the charger to the HiKOKI
Authorized Service Center.
8
Plugged into power source
Battery capacity at less than 50%
Battery capacity at less than 80%
Battery capacity at more than 80%
Battery overheated. Unable to
charge. (Charging will commence
when battery cools)
Malfunction in the battery or the
charger