Dean Super Runner SR52G Installatie- en bedieningshandleiding - Pagina 5

Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} Dean Super Runner SR52G. Dean Super Runner SR52G 16 pagina's.

Pagina afdrukken
For units equipped with legs: Lift the unit and move it into its final position. Do not drag or push the fryer into position.
Doing so may damage the legs. Level the unit front to back and side to side. If the fryer is not level, the unit will not
function efficiently. Super Runner Series gas fryers cannot be curb mounted and must be equipped with either legs or
casters provided.
A. Adjust leg height with an adjustable or 1-1/16-inch (27-mm) open-end wrench by turning the hexagon-shaped foot
on the bottom of the leg. NOTE: The foot is for minor leg height adjustment only. Do not adjust outward more
than ¾-inch (19-mm).
B. When leveling the unit, the leg body should be held firmly to keep the leg from bending or rotating while turning the
foot to the required height.
For units equipped with casters: Roll the unit into its final position and lock the front casters.
1.3 Pre-Connection Preparation
If the incoming gas pressure is in excess of ½" PSI (3.45 kPa/35 mbar), a step-down regulator will be
CE UNITS ONLY:
Dean Super Runner gas fryers have obtained CE markings for countries and gas categories shown below:
Countries
BE
Belgium
DE
Germany
DK
Denmark
ES
Spain
FR
France
GB
Great Britain
GR
Greece
IR
Ireland
IT
Italy
LU
Luxembourg
NL
The Netherlands
PT
Portugal
NON-CE UNITS ONLY:

NATIONAL CODE REQUIREMENTS:

This equipment is to be installed in compliance with the Basic Plumbing Code of the Building Officials and Code
Administrators International, Inc. (BOCA) and the Food Service Sanitation Manual of the U.S. Food and Drug
Administration.
This equipment is manufactured to use the type of gas specified on the rating plate attached to the door. Connect
equipment stamped "NAT" only to natural gas and that stamped "PRO" only to LP (Propane) gas.
SUPER RUNNER SERIES GAS FRYERS
CHAPTER 1: INSTALLATION INSTRUCTIONS
Supply Pressures and Gas (mbar)
G20
G31
G20
G31
G20
G20
G31
G20/G25
G31
G20
G31
G20
G31
G20
G31
G20
G20/G25
G31
G25
G31
G20
G31
WARNING
required.
20/25
37
20
50
20
20
37 and 50
20/25
37 and 50
20
37
20
37 and 50
20
37
20
20/25
50
25
50
20
37
1-2
Appliance Categories
IIE(R)B3P
I2E
I3P
I2H
II2H3P
II2ESI3P
II2H3P
II2H3P
II2H3P
I2H
II2E3P
II2L3P
II2H3P