Dean Forge Hembury 6 Gebruiksaanwijzing - Pagina 3

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Dean Forge Hembury 6. Dean Forge Hembury 6 15 pagina's.

The primary air control is indicated with a single slot. This control is used for lighting the fire

or boosting the fire. This is also the main control when burning solid fuel. Pull fully out for

maximum air flow to the fire and fully in to close the air flow.

The secondary air wash control is indicated with double slots. This controls the preheated air

wash, once the fire in the stove is established this is the control that should be used to control

the fire when burning wood.

The secondary control works as follows:

Pull out fully for maximum air flow into the fire and push in to slow the air to the fire and

create the required flame pattern. The stove is at its maximum efficiency at about 75% closed.

The appliance must not be operated with the air controls or door left open except as directed in

the instructions.

Lighting The Stove when using Wood

Lay a fire of sticks and paper. Firelighters can be used if necessary. Check the secondary air

lever is fully open and the primary air is partially open. Light the fire and as the fire catches

the paper you may then fully open the primary air vents.

When the fire has fully established and the logs are burning well shut the primary air vent and

control the fire with the secondary air wash lever (if you are unable to sustain the fire with

secondary control it is very likely that your logs have a high moisture content).

Refuelling

When refuelling the fire, to ensure clean burning, the primary air control should be opened for

a couple of minutes so that flames are established on the newly fuelled logs. The primary air

should be closed once these flames are fully established and the logs have become blackened.

After refuelling, it is recommended that you do not leave the appliance unattended until it is

certain that the logs are burning well with a sustained flame.

Please Note: For long periods of burning you will need to use seasoned hard wood. Longer

periods of burning may cause the door glass to blacken, but this can be cleared when you get

the fire back up to temperature and providing the secondary air control is slightly open this will

then stay clear.

Do not load the fuel above the log retainer.

Please note:

If there is insufficient burning material in the fire bed to light a new fuel charge, excessive

smoke emission can occur. Refuelling must be carried out onto a sufficient quantity of glowing

embers and ash that the new fuel charge will ignite in a reasonable period. If there are too few

embers in the fire bed, add suitable kindling to prevent excessive smoke

Fuel overloading

The maximum amount of fuel specified in this manual should not be exceeded, overloading

can cause excess smoke.

The door should always be closed between refuelling to prevent fumes and spillage from the

firebox.