HIKVISION D8T Series Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} HIKVISION D8T Series. HIKVISION D8T Series 17 pagina's. Turbo hd turret camera
Ook voor HIKVISION D8T Series: Gebruikershandleiding (17 pagina's), Gebruikershandleiding (17 pagina's), Gebruikershandleiding (12 pagina's), Gebruikershandleiding (16 pagina's), Gebruikershandleiding (15 pagina's), Gebruikershandleiding (12 pagina's), Gebruikershandleiding (17 pagina's)

Pagina afdrukken
HIKVISION D8T Series Gebruikershandleiding
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are
required to fix the camera. For wooden
wall/ceiling, self-tapping screws are required.
5. Connect the corresponding power cord, and video
cable.
6. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the surveillance angle.
1)
Loosen the No.1 adjusting screw to adjust the pan
position [0° to 360°]. Tighten the No.1 adjusting
screw.
2)
Loosen the No.2 adjusting screw to adjust the
tilting position [0° to 180°]. Tighten the No. 2
adjusting screw.
3)
Loosen the No.3 adjusting screw to adjust the
rotation position [0° to 360°]. Tighten the No.3
adjusting screw.

Ceiling/Wall Mounting with Junction Box

2.2.2
Before you start:
You need to purchase a junction box separately.
Steps:
1. Paste the drill template on the ceiling/wall.
2. Drill screw holes and the cable hole (optional) in the
ceiling/wall according to the holes of the drill
template.
Note:
Drill the cable hole, when adopting ceiling outlet to
route the cable.
3. Take apart the junction box, and align the screw
holes of the bullet camera with those on the
Junction box's cover.
4. Fix the camera on the junction box's cover with
three supplied screws.
5. Secure the junction box's body with supplied screws
on the ceiling/wall.
Figure 2-11 Install the Junction Box
6. Route the cables through the bottom cable hole, or
the side cable hole of the junction box.
7. Combine the junction box cover with its body with
supplied screws on the junction box's cover.
Figure 2-10 3-Axis Adjustment
0° to 180°
0° to 360°
0° to 360°