Majacraft Suzie Handmatig - Pagina 8
Blader online of download pdf Handmatig voor {categorie_naam} Majacraft Suzie. Majacraft Suzie 12 pagina's.
7. Crank Assembly
Required:
3 - M5x20mm silver counter-sunk screws
3mm allen T-wrench
The drive wheel has been predrilled with the holes which line up with the holes on the crank
assembly. Make sure the drive belt is on before starting!
Do not fully tighten the centre bolt until you have aligned and started screwing in the two bolts on the
sides.
When the three bolts are all in place, you can finish tightening
them up.
8. Conrods to Pedals
Required:
Posidrive screwdriver
The green joiners have already been put in place in the wooden conrods. Place the wheel in front of
you so the crank and drive wheel are facing you.
We will start with the pedal on your left hand side. Select the conrod that is CLOSEST to YOU. It is on
the end of the curved arm and is attached to the crank assembly with the special right angle rod end
connector. Push the green joiner into the hole at the end of the pedal on your left until it protrudes by
about 2mm. Screw the 25mm gold screw into the hole on the side of the pedal so it holds the green
joiner in place.
Align the holes on the drive wheel with the holes in
the crank assembly and screw it into place using the
3mm Allen key. It is recommended that you insert
the centre bolt first. This will reduce your chances of
possibly scratching your drive wheel.
7b
8
7a
7c
majacraft