CentralPneumatic 68019 Handleiding voor installatie en gebruik - Pagina 12
Blader online of download pdf Handleiding voor installatie en gebruik voor {categorie_naam} CentralPneumatic 68019. CentralPneumatic 68019 19 pagina's. 2-in-1 18 gauge nailer-stapler
Ook voor CentralPneumatic 68019: Gebruikershandleiding (20 pagina's)
Pagina afdrukken
it against the workpiece again. The
tool must not cycle (fire). If it fails to
perform in the manner explained in bold,
have it repaired by a qualified service
technician.
Loading the Tool
FROM ACCIDENTAL OPERATION,
BEFORE LOADING:
• Wear ANSI-approved safety
goggles with side shields. Other
people in the work area must also
wear ANSI-approved impact safety
goggles with side shields.
• Release the trigger.
• Detach the air supply.
• Attempt to fire the Tool into a
piece of scrap wood to ensure
that it is disconnected and is
incapable of firing any fasteners.
1.
Depress the Latch (64) and pull back on
the Moveable Magazine (55), pulling it
out of Fixed Magazine (52).
2.
Insert the fasteners into the Moveable
Magazine. If loading staples, fit the
crown of the staples so they fit over and
ride on the rail of the Magazine.
3.
After the nails or staples are loaded,
slide the Moveable Magazine back into
Fixed Magazine until the Latch snaps
back into place, locking the Moveable
Magazine.
Note: The small window gauge on the left
side of the Moveable Magazine indicates
how many fasteners remain inside
Nailer-Stapler.
General Operating Instructions
1.
Test the Tool, as directed in the prior
section, before each use.
Page 12
TO PREVENT
SERIOUS INJURY
For technical questions, please call 1-800-444-3353.
2.
If automatic oiler is not used, add a few
drops of Pneumatic Tool Oil to air intake
of tool before use. Add a few drops
more after each hour of continual use.
3.
Attach the Nailer/Stapler to the air
supply. Start your compressor and
check the pressure, making sure it is set
at the recommended 70-120 PSI.
4.
To fire, place the nose of the Nailer/
Stapler on the workpiece. The Nailer/
Stapler should not fire if the Safety is not
depressed. Once depressed, gently and
briefly squeeze the Trigger once. Do not
fire repeatedly; nails or staples could
bounce off of one another, damaging
the work piece or causing PERSONAL
INJURY.
5.
If the tool requires more force to
accomplish the task, verify that the tool
receives sufficient, unobstructed airflow
(CFM) and pressure (PSI).
CAUTION! TO PREVENT TOOL AND
ACCESSORY FAILURE, RESULTING
IN INJURY: Do not exceed the tool's
maximum air pressure rating. If the
tool still does not have sufficient force at
maximum pressure and sufficient airflow,
a larger tool would then be required.
6.
After use, to prevent accidents:
a. Release the trigger.
b. Detach the air supply.
c. Attempt to fire the Tool into a piece
of scrap wood to ensure that it is
incapable of firing any fasteners.
d. Release the trigger again.
e. Wipe external surfaces with clean,
dry cloth.
f. Store indoors out of children's reach.
SKU 68019