CentralPneumatic 69927 Gebruikershandleiding - Pagina 12
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} CentralPneumatic 69927. CentralPneumatic 69927 20 pagina's. Framing nailer 28 angle
Pagina afdrukkenContact Safety Trip (Bump Fire) Mechanism Definition
The contact safety trip (or bump fire) mechanism allows rapid fire. Use the Mode Switch near the Trigger
to change modes. The tool should only fire if the Safety Nosepiece is pressed against the workpiece
and the trigger is pulled. It should fire again if the trigger is released and pulled OR if the safety is
lifted and pressed against the workpiece again. The Tool should not fire if the Safety Nosepiece is
not pressed against an object. Contact safety trip / bump fire should only be enabled and used
by skilled operators who are aware of the hazards and use proper, safe work practices.
Contact Safety Trip (Bump Fire) Mechanism Testing Procedure
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Point the tool at a piece of scrap wood when testing.
1. Disconnect the tool from the air supply.
2. Load the magazine with fasteners.
3. Check that the Trigger and the Safety Nosepiece
move freely, without sticking.
4. Connect the air supply to the tool and
set within the Operating Air Pressure
indicated on the Specification chart.
5. Test the tool by pressing the Safety Nosepiece
against the workpiece without pulling the Trigger.
The tool must not cycle (fire).
If it cycles (fires), stop immediately and have it
repaired by a qualified service technician.
Safety Trip Mode Switch
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL FIRING:
• Release trigger and point tool in a safe direction before changing safety trip mode.
• ONLY operate the tool with the switch fully in one of the safety trip mode positions.
1. Turn the switch to the
to enable Single Sequential operation.
This operation is safer and should
be used whenever practical.
2. Turn the switch to the
to enable contact trip / bump fire operation.
This operation is more dangerous.
Only a skilled operator who is aware of the
hazards and uses proper, safe work practices
should use contact trip / bump fire operation.
Page 12
(single nail) setting
(multiple nail) setting
For technical questions, please call 1-800-444-3353.
6. Hold the tool away, or off of the workpiece.
The Safety Nosepiece should return to its original
position. Squeeze the Trigger.
The tool must not cycle (fire).
If it cycles (fires), stop immediately and take
the tool to a qualified service technician.
7. Press the Safety Nosepiece against the workpiece
and squeeze the Trigger.
The tool must cycle (fire) only once.
Release the trigger, slide the nailer to a fresh piece of
wood, and squeeze it again.
The tool must cycle (fire) again only once.
With the Trigger depressed, carefully lift the tool
and press it against the workpiece
again in a new location.
The tool must cycle (fire) again only once.
If it fails to act in the manner explained in bold,
have it repaired by a qualified service technician.
Single Sequential
Position
Figure C: Trigger Mode Switch Positions
Contact Trip
Position
Item 69927
69928