Bristan DSC 3HBAS C Handleiding voor installatie-instructies - Pagina 10

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Bristan DSC 3HBAS C. Bristan DSC 3HBAS C 16 pagina's. Descent tap range
Ook voor Bristan DSC 3HBAS C: Installatie-instructies en gebruikershandleiding (18 pagina's)

Pagina afdrukken

Installation Cont.

Wall Mounted Basin Mixer and Bath Filler

1. Decide on the final position of the basin mixer/

bath filler. Install suitable battons into the wall

cavity if required to support the tap body.

2. Plumb the hot and cold water supply pipes to

the required position.

3. Secure mixer body using the screws and wall

plugs supplied.

4. Attach the supply pipework to the hot and cold

inlets (hot on the left and cold on the right when

viewed from the front) ensuring the olive is fitted

to the copper pipe work. Tighten the compression

nut to secure the pipework and create a water

tight seal.

Note: Before finishing the wall surface turn on

both water supplies to check for any leaking

connections.

5. Finish the wall surface.

Note, it is important that a sufficient amount of

the spout connecting tube and valves are left

exposed to allow the spout and valve shrouds to

fit.

6. Fit the spout and tighten the grub screws to

secure in position.

7. Screw the valve shrouds onto the valves using

the screws supplied. Push the plinth over the

shroud.

8. Fit the spline adaptors to the valve splines

using the screws and washers supplied.

9. Push the handles onto the valve shrouds and

tighten the grub screws.

10. Turn on both water supplies and operate the

handle letting the water flow for a few minutes to

flush the system.

Need help? Give us a call on 0844 701 6273 and speak to one of our trained advisers.