Bristan Manhattan MH SNK WHT Montage-instructies - Pagina 2
Blader online of download pdf Montage-instructies voor {categorie_naam} Bristan Manhattan MH SNK WHT. Bristan Manhattan MH SNK WHT 2 pagina's. Monobloc kitchen mixer
Pagina afdrukken
WATER PRESSURE
This mixer is suitable for use at all supply pressures.
If the fitting is installed at low pressure (tank fed), then the minimum
height from the outlet of the nozzle to the underside of the cold tank
should be 2 metres to ensure adequate performance.
Operating Pressures: Min 0.2 bar, Max 7.0 bar.
This mixer should be installed in compliance with Water
Regulations. For further details contact your Local Water Authority.
FULL RUBBER WASHER
SINK
RUBBER 'C' PLATE
METAL 'C' PLATE
INSTALLATION
1. Identify all components and check for completeness, particularly
before arranging installation
2. Fit the mixer body to the sink using the 'C' plate fixing kit. The full
rubber washer goes between the fitting and the sink. The optional
nylon ring can be used between the underside of the sink and the
rubber washer if need be. The 'C' shaped rubber and metal washers
also go on the underside of the sink.
3. Fit the flexi tails to the fitting and connect the hot and cold
supplies.
4. Fully open both valves, letting them run for a few minutes to flush
the system.
5. Check all joints and connections for leaks.
6. See over the page for aftercare instructions.
MAINTENANCE
All valve types: - If the fitting begins to drip
1. Turn off the water supply.
2. Remove fitting head and valve.
3. Carefully clean seating and rubber washer.
4. Replace valve and turn on the water supply.
5. Contact our helpline if problem persists.
Please Note: In the unlikely event you find a part missing please
contact our Customer Service Help line on
for immediate dispatch of part.
or email
0844 701 6273