AIRFLO PSV-8L Bedienings- en onderdelenhandleiding - Pagina 8

Blader online of download pdf Bedienings- en onderdelenhandleiding voor {categorie_naam} AIRFLO PSV-8L. AIRFLO PSV-8L 17 pagina's.

OPERATORS MANUAL – PSV-8L (ELECTRIC)

Spreader Maintenance

1. Use dielectric grease on all electrical

connections before an electrical

connection is made or after a

connector is disconnected.

2. Grease the following:

a. Idler Shaft Bushings (2)

b. Drive Shaft Bushings (2)

c. Spinner Shaft Bushings (2)

d. Flanged Bearing located

between gearbox and clutch

e. Gearbox Input Shaft Bearing.

NOTE: Do not over grease. Can

cause seal damage.

3. Check the alignment of the

sprockets periodically.

4. Inspect the bearings in the motor

and the pillow blocks for proper

lubrication periodically.

5. Maintain the correct tension on the

following chains using the following

information:

a. Drag Chain Tension-Check to

make sure that the distance

between the end of the rail and

the point of contact between the

chain and the lower flange of the

rail is 26" to 30". See Figure 13.

Turn the screws shown in

Figures 14 and 15 to adjust the

chain tension as needed.

AIR FLO MANUFACTURING., CO INC.

Figure 13.

Figure 14.

Figure 15.

7 |

P a g e