Bristan IRSD1-BN Installatie-instructies en gebruikershandleiding - Pagina 12
Blader online of download pdf Installatie-instructies en gebruikershandleiding voor {categorie_naam} Bristan IRSD1-BN. Bristan IRSD1-BN 16 pagina's. Infrared automatic soap dispensor
Ook voor Bristan IRSD1-BN: Installatie-instructies en gebruikershandleiding (16 pagina's)
Pagina afdrukken
Troubleshooting
Symptom
Spout does
not dispense
soap.
Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.
12
Cause
Sensor cable not
connected.
Possible blockage in
dispense tube or dispense
cable.
Low or no soap in bottle.
No electrical power to
pump.
Soap used not suitable for
this product.
Remedy
Check that the sensor
cable is connected. If not
connected, connect sensor
cable. Refer to 'Installation'
section on pages 6-8.
Remove pump from bottle
and clean tube.
Remove dispense cable from
pump and clean.
Fill bottle with liquid soap.
When soap is at
approximately 20mm from
the bottom top soap up.
Ensure power cable is
connected. Refer to
'Installation' section on pages
6-8.
This product can only be
used with hand-washing
soaps that fall within the
viscosity shown in the
Specification. Due to the
complex nature of the hand
sanitisers/gels being used,
it is difficult to predict how
they act when pumped
(even if on paper they
have the correct viscosity).
Some are manufactured to
thicken when friction/heat/
movement is applied in order
to help them absorb, and this
property can block the pump
mechanism.