Gamma 5002 Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Gamma 5002. Gamma 5002 18 pagina's.

tremely high tensions, additional tightness may be required. Note: If the string slips in the

string clamp while tensioning, adjust the gap between the clamp jaws as per the

instructions on page 11.

STRINGING THE FRAME

Fixed Clamp Operation - Step 2

Rotate the winged lock knob clockwise to

secure the clamp base to the turntable.

Reverse the clamping procedure to unlock

the string clamp.

The winged lock knob should be tightened

enough to prevent clamp base slippage on

the turntable, when the desired tension is

placed on the string. To go from the loose

position to the clamped position and back,

generally requires about 1/2 to 3/4 quarters

of a turn. Although when stringing at ex-

Clamping the First Main String

To begin stringing the main strings, thread

the two ends of the string through the two

center holes at the appropriate end of the

frame and continue through the opposite

center holes. Thread one end of the string

through the adjacent grommet hole and pull

excess by hand.

Secure one of the strings using a string

clamp.

Pulling Tension

Wrap the loose section of string once around

the roller guide and insert the string between

the

diamoind dust coated string gripper

plates. Pull the string perpendicular to the

gripper plates while slowly rotating the

tensioner crank clockwise until the brake

lever pops out of the latching block. The

string is now tensioned and can be clamped

in place with the remaining fixed clamp.

Repeat the above steps until all main strings

are installed. Tie off ends of main strings as

per racquet manufacturers recommenda-

tions.