Gamma 5003 Gebruikershandleiding - Pagina 14

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Gamma 5003. Gamma 5003 20 pagina's. 6 point mounting
Ook voor Gamma 5003: Gebruikershandleiding (20 pagina's), Gebruikershandleiding (19 pagina's), Gebruikershandleiding (20 pagina's)

Pagina afdrukken

1. Machine Parts

DISK BRAKE ADJUSTMENT

Adjusting the Tensioner Brake

Step 1

After stringing many racquets, the brake of

the tensioner may need to be adjusted. The

Brake Adjustment Bolt can be accessed

through the hole in the face of the tensioner

cover, which does not need to be removed

for adjustment. The Tensioner Cover has

been removed in the pictures for illustration

purposes.

A - Cover Screws

B - Lock Bolt

Step 2

With the brake lever engaged, loosen the

lower hex bolt located on the back side of the

tensioner frame with the 4 mm allen wrench.

Note: The hex bolt should only be loosened

until loose enough to turned by hand and

must not be removed completely.

C - Brake Adjustment Bolt

Step 3

With the hex bolt loosened and the brake

lever engaged in the latch, insert the 6 mm

hex wrench into the set screw locted inside

the nut located at the base of the brake lever.

To tighten the braking mechanism, turn the

set screw counter clockwise by about 1/8

turn. Re-tighten the hex bolt on the back side

of the tensioner frame and check for brake

tightness. The tensioner should move freely

along the track with the brake lever engaged

and should hold tension with the brake lever

released. If more adjustment is needed,

repeat steps above until properly adjusted.