Gamma Progression ES II Gebruikershandleiding - Pagina 12

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Gamma Progression ES II. Gamma Progression ES II 16 pagina's.

MAINTENANCE and ADJUSTMENTS

Note: The string clamps supplied with your stringing machine can accomodate tight string patterns such as badminton. Depending on

the string pattern, the clamp may spread the strings slightly which will not compromise the quality of the string job.

Adjusting the Clamp Jaws

"Quick Action"

The

according to what string type, construction, and gauge you are

using.

To adjust the gap (clamping pressure) between the clamp jaws,

insert the string through the racquet as if you were beginning the

main strings. Clamp the strings and pull tension. If the string slips

through the jaws of the clamp, tighten the clamp by compressing

the clamp jaws together by hand while turning the Adjustment

Knob, in the clockwise direction. If the clamp leaves impressions

Adjustment

or damages the string, it may be excessively tight and should be

Knob

adjusted by turning the hex screw counter clockwise to open the

gap between the jaws. The clamp jaws should be cleaned

periodically to be free from dirt, oil, and any string coating for them

to grip properly.

Clamp Base Locking Nut Adjustment

In the event the Locking Lever rotation is insufficient to ensure

smooth operation of the clamp base, very minor adjustments to

the Clamp Base Locking Nut can be made with the supplied

17mm wrench. Tighten or loosen the locking nut in very small

increments to provide more clamping pressure or running clear-

ance as needed.

Turntable Bushing Adjustment

The Progression ESII is adjusted at the factory for optimum

performance. After time and use, the turntable bushings may

need minor adjustment. An adjustment is indicated when notice-

able turntable looseness or wobble occurs while stringing.

To adjust the fit between the turntable pin and the bushings,

tighten the set screw at the top of the bushing using a 3mm hex

wrench. Tighten until the turntable rotates smoothly without

excessive free play.

Clamps will need minor adjustments