Gamma Progression ES II+ Gebruikershandleiding - Pagina 14

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Gamma Progression ES II+. Gamma Progression ES II+ 17 pagina's.

Gamma Progression ES II+ Gebruikershandleiding

TROUBLESHOOTING TIPS

PROBLEM
String slips in clamps.
String slips in gripper.
String clamp base slips on turntable.
Electrical system does not function.
String tension too tight or too loose.
To change the fuse, remove the power cord and pull the fuse holder straight out. Remove
the old fuse from the holder and replace it with the supplied spare. Replace the fuse holder
into the machine and check for proper operation.
With time and use, the clamping surfaces of your machine may become oily or dirty and
result in string or clamp slippage while stringing. Periodic cleaning of the following parts is
recommended.
String Clamps
Clean the inside gripping surfaces of the string clamp jaws by inserting a cloth or pipe cleaner
soaked with isopropyl alcohol between the jaws and rub back and forth. If the build-up is
excessive, dismantle the string clamp jaws to expose the gripping surfaces by removing the
adjustment screw. Using a small nylon brush, (such as a toothbrush), scrub the inside
surfaces until all debris is removed. Clean the jaws with isopropyl alcohol and re-assemble.
String Clamp Base
Clean the base of the clamps and the top of the turntable with isopropyl alcohol.
String Gripper
Follow the same procedure for cleaning the string clamps.
- Adjust gap between jaws.
- Clean clamp jaws.
- Clean gripper jaws.
- Make sure string is wrapped over top
jaw of gripper prior to inserting between
gripper jaws.
- Adjust Clamp Base Locking Nut.
- Check power source.
- Check power cord connection.
- Check stringing machine fuse.
- Check for proper voltage setting (110/
220) of machine.
- Call customer service.
- Check tension using a tension
calibrator and adjust machine calibra-
tion if necessary
FUSE REPLACEMENT
CARE and CLEANING
13
SOLUTION