Gamma Progression STII Gebruikershandleiding - Pagina 14

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Gamma Progression STII. Gamma Progression STII 19 pagina's.

MAINTENANCE & ADJUSTMENTS

screw counter clockwise to open the gap between the jaws. The clamp jaws should be

cleaned periodically to be free from dirt, oil and any string coating for them to grip properly.

Note: The string clamps supplied with your stringing machine can accomodate tight string

patterns such as badminton. Depending on the string pattern, the clamp may spread the strings

slightly which will not compromise the quality of the string job. String clamps designed

specifically for badminton racquets are available.

Adjusting the Clamp Jaws

The Quick Action Clamps will need minor adjustments

according to what string type, construction, and gauge

you are using.

To adjust the gap (clamping pressure) between the

clamp jaws, insert the string through the racquet as if

you were beginning the main strings. Clamp the strings

and pull tension. If the string slips through the jaws of

the clamp, tighten the clamp by compressing the clamp

jaws together by hand while turning the Adjustment

Knob, in the clockwise direction. If the clamp leaves

Adjustment

impressions or damages the string, it may be exces-

Knob

sively tight and should be adjusted by turning the hex

Clamp Base Locking Nut Adjustment

In the event the Locking Lever rotation is

insufficient to ensure smooth operation of

the clamp base, very minor adjustments to

the Clamp Base Locking Nut can be made

with the supplied 17mm socket. Tighten or

loosen the locking nut in very small incre-

ments to provide more clamping pressure or

running clearance as needed.

Quick Action Clamp Base Removal

Quick Action clamp bases can be removed

from the turntable for maintenance or clean-

ing by removing clamp stop located at the

end of the slot in the turntable. To remove the

clamp stop, remove the two screws holding

the clamp stop in place from the underside of

the turntable. Lift the clamp stop out of the

slot, slide the clamp base to the end of the

slot and lift it out. Replace the clamp base

and clamp stop in reverse order.