Gamma X-Stringer XLT Gebruikershandleiding - Pagina 9
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Gamma X-Stringer XLT. Gamma X-Stringer XLT 20 pagina's. Electronic stringing machine
Pagina afdrukken
MOUNTING THE FRAME
Caution: To avoid racquet damage, the center posts should not contact the racquet prior to
locking down the support posts.
and attempts are made to move it. Should any supports lose contact with the frame while
stringing, they should be re-tightened.
Caution: Do not overtighten any of the supports as racquet damage may occur.
Adjusting the Frame Support Posts
Loosen the lock bolts of the frame support
posts and space them apart with the frame
support slides separated by the approximate
length of the racquet head. Although it is not
required, it is good practice to center the sup-
port posts on the turntable. Lock one of the
posts in position by tightening the lock bolt
and position the other post until the frame
support slide is positioned near the inside
surface of the racquet frame. Securely tighten
the lock bolt of the second support post.
Tightening the Frame Supports
Tighten the Frame Support Slides by turn-
ing the adjustment knob clockwise until
snug against the racquet frame and slight
resistance is felt.
Caution: Overtightening the Center Supports
will stretch the head of the racquet and could
cause racquet damage.
Frame Shoulder Support Adjustment
Simultaneously rotate the shoulder support
adjustment knobs clockwise until both shoulder
supports gently and squarely contact the frame.
Rotate the shoulder supports as needed so the
pads make fl ush contact with the racquet frame.
Repeat this procedure for the remaining sup-
port posts.
The supports should be tightened to the point
where the racquet frame will not move in the
mounting system when the handle is grasped
9