Airflow Ceiling fans Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Airflow Ceiling fans. Airflow Ceiling fans 12 pagina's. Builder’s choice gallery edition

Pagina afdrukken

Installing a New Ceiling Fixture Outlet Box

If you do not have an existing fixture located where you wish

to place your fan, an approved ceiling fixture outlet box must

be installed and wired.

WARNING: To reduce the risk of fire, electrical shock,

or personal injury, mount to outlet box marked

acceptable for ceiling fan support using the

mounting hardware provided with the outlet box.

Proceed with installation as follows:

Step 7. Attach the bracket to the ceiling fixture outlet

box with the mounting hardware included with the outlet

box.

Tighten the screws firmly by hand only, being careful not

to bend the bracket by overtightening.

NOTE: On sloped ceilings, align the canopy

opening towards the top or room peak.

CAUTION: To reduce the risk of

personal injury, use only the

mounting hardware provided with

the approved outlet box to install

the crossbar mounting bracket.

Step 8. To hang the fan body in the mounting

bracket, hold the fan body firmly and insert

the ball into the bracket opening. Check that

no wires were pinched. Rotate the fan body

until the slot in the nylon ball fits into the

pin opposite the bracket opening.

CEILING FIXTURE OUTLET BOX

MOUNTING BRACKET INSTALLATION

HANGING THE FAN

BALL

OPTION

WIRE

Using Existing Ceiling Fixture Outlet Box

After turning the power OFF at its source (either circuit breaker

or fuse box), lower the old fixture and disconnect the wiring.

Check the ceiling fixture outlet box to be sure that it is

marked 'Approved for ceiling fan mounting' . If it is not, a new

box must be installed.

CEILING FAN

APPROVED

OUTLET BOX

CEILING

WIRING

FLAT

WASHER

SLOT

CAPPED BLUE D1-OPTION WIRE ON 3-SPEED ONLY

FOR INDEPENDENT W-80 LIGHT CONTROL

MOUNTING

BRACKET

GREEN

GROUND

APPROVED

WIRE

OUTLET

BOX

HARDWARE