Centurion D5-EVO REPAIR Configuratiehandleiding - Pagina 8
Blader online of download pdf Configuratiehandleiding voor {categorie_naam} Centurion D5-EVO REPAIR. Centurion D5-EVO REPAIR 13 pagina's. Sliding gate operator
Ook voor Centurion D5-EVO REPAIR: Handleiding voor installatie-instructies (14 pagina's), Handleiding voor programmering (4 pagina's)
Pagina afdrukken
A warning buzzer will sound (where applicable) as per the table below:
Priority
Inhibitor name
Break-in alarm
Ambush alarm
Multiple collision
Battery low
Auxiliary overload
Holiday Lockout
Emergency stop
Time-barring
No limits set
Mains failure
Beams broken (any)
Beams failure
DOSS disconnected
Fuse blown
Motor disconnected
Bridge damaged
Gate stalled
No magnet detected
Gate will close fully and then shutdown for two minutes
Number of beeps
Continuous tone for 30 seconds
Continuous tone until IRBs are cleared
Periodic until condition is cleared by user (500/500ms)
Three beeps periodically for 30 seconds
Five beeps periodically for 30 seconds
One beep periodically for 30 seconds
One beep periodically for 30 seconds
One beep periodically for 5 seconds
Three short beeps for 5 seconds
Two beeps periodically for 30 seconds
One beep periodically for 30 seconds
Five beeps periodically for 30 seconds
Five beeps periodically for 30 seconds
Five beeps periodically for 30 seconds
Five beeps periodically for 30 seconds
Five beeps periodically for 30 seconds
Four beeps periodically for 10 seconds
Periodic while gate runs (500/500ms)
Gate
Fault type
continues
to operate
Alarm
N/A
Alarm
N/A
Collision
No
Power system fault
Yes*
No
Hardware
User
No
User
No
User
No
Lost
No
Power system fault
Yes
User
No
Hardware
No
Hardware
No
Hardware
No
Hardware
No
Hardware
No
Collision
No
Lost
Yes
User can
correct
error
N/A
N/A
Yes
Yes
No
Yes
Yes
Yes
Yes
Yes
Yes
No
No
Yes
Yes
No
Yes
Yes