Green Brook AC3000N Installatie-instructies
Blader online of download pdf Installatie-instructies voor {categorie_naam} Green Brook AC3000N. Green Brook AC3000N 2 pagina's.
Pagina afdrukken
Installation Instructions
For the Air Curtain
Model No: AC3000N
IMPORT NT
This product should be installed by a
competent person and in accordance with
the current IET Wiring Regulations, and
Building Regulations. If in doubt,
consult a qualified electrician.
• This product is not intended to be used by
children and persons with sensory, physical
and/or mental impairments that would
prevent them from using it safely.
• Extreme caution is necessary where children
or persons with reduced physical, sensory or
mental capabilities may come into contact
with the heater when in use.
WARNING
• In order to avoid overheating do not cover
or obstruct grilles or air intake openings
when in use.
• The Air curtain must not be located
immediately adjacent to or under/against
an electrical socket outlet.
• Do not operate the Air curtain with a
damaged cord/plug or if heater
malfunctions. If the supply cord is damaged
it must be replaced by a qualified
electrician
• Before making any fixing holes make sure
there are no pipes or cables below the
surface.
• Make sure the Air curtain is anchored to a
solid surface which can take the weight of
the Air curtain.
• This Air curtain is for indoor use only.
• This Air curtain must be connected to earth.
• Position the Air curtain ensuring that hot air
cannot blow directly onto flammable
surfaces.
• This Air curtain is not equipped with a
device to control the room temperature. Do
not use this Air curtain in small rooms when
they are occupied by persons not capable
of leaving the room on their own, unless
constant supervision is provided.
• If the unit overheats, thermal switches will
cut the power and will restore the power
when the unit has cooled down. However, if
the unit overheats severly, thermal fuses will
isolate the power, these fuses will not reset
and cannot be replaced by the user.
INTRODUCTION
The Air Curtain unit is designed for easy
installation and can be wall or ceiling mounted.
The unit has a fan and two heat settings and its
angle can be adjusted. This unit is ideal for
providing a heated air curtain if mounted over
doorways and reduces draughts and the
discomfort of cold air when doors are opened.
INST LL TION
Switch off mains supply and remove the
appropriate circuit fuse or MCB before
commencing installation or maintenance.
1. Remove the four screws from the front
panel and remove it see diagram (1).
2. Loosen, but do not remove the retaining
bolt using a spanner as shown in
diagram (2) and remove the bracket
- see diagram (5).
3. Make fixing holes in wall or ceiling using
the wall bracket as a template and
secure bracket using the fixings supplied.
If the fixings supplied are not suitable for
your installation, use appropriate
alternative fixings - see diagram (3).
Note: the bracket must be fixed to a
solid point e.g. brick, concrete, stud or
joist.
4. Hang the Air Curtain on the bracket,
ensure that the bracket is located
between the bolt and the serrated
washer and that the bolts are at the end
of the slots in the bracket see diagram
(2).
5. Adjust the Air Curtain to the required
angle and tighten the bolts using a
spanner. Take care not to overtighten.
6. Re-fit the front panel.
7. Connect Air Curtain to mains supply
using a switched 13A fused spur to the
corresponding symbols.
Live
- Brown or Red
Neutral
- Blue or Black
Earth
- Green and Yellow
8. Restore power and switch on the main
switch (red illuminated). Heating levels
are controlled by two switches (4) for
half and full load see diagram 5.
Dia:1
Dia:2
Dia:3
Dia:4