Major tech MT800 Gebruiksaanwijzing - Pagina 5

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Major tech MT800. Major tech MT800 8 pagina's. Analogue multimeter

WARNING: Use with extreme caution. Follow all safe guards suggested

in the manual in addition to normal safety precautions. Do not use this

meter if you are unfamiliar with electrical circuits and testing procedures.

4. TIPS FOR USING YOUR MULTIMETER

When using this tester, pay particular attention to polarities and check

positive and negative points. The red lead connects to positive points and

the black lead to negative. If you are checking unknown voltage and

currents, use highest range first then next lower range, and so on until

readings can be obtained. For most accurate readings, keep the meter lying

flat. Also, use a range setting that results in a reading in the upper third of

the meter scale. For exact readings, look at the scale from the point where

the pointer and its reflection on the mirror come together, otherwise a

reading error may result due to parallax.

5. TEST LEADS

Only use the same type of test leads that are supplied with this meter.

These test leads are rated for 1000V.

A battery is required for resistance measurements. To install, use a phillips

screwdriver to remove the screw on the back cover. Pull apart the front and

back covers. Insert 1 AA battery (not supplied) in the battery compartment

observing correct polarity. Never leave a weak or dead battery in your unit.

Even leak-proof types may leak damaging chemicals. Remove the battery

when you don't intend to use your unit for more than a week.

To avoid electric shock, disconnect measuring terminals before installing

or removing battery. Open cover only when replacing battery, do not

touch any inside area other than the battery.

CAUTION: the MAX input limit for voltage and current measurements

between '+' and '－' is 500V AC, 500V DC and 250 mA DC.