Major tech MT245 Gebruiksaanwijzing - Pagina 16

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Major tech MT245. Major tech MT245 20 pagina's. Car battery tester

CUR: Current Voltage

MAX: Maximum Voltage during lgnition

MIN: Minimum Voltage during Ignition

The waveform will stay in static until there's changes in the voltage

detected.

Various vehicle voltage analyses.

Ÿ Discharge Voltage: When the Ignition OFF engine OFF (Over 20

Minutes) the Discharge

Ÿ Voltage should be around 12V. If the discharge voltage is lower than

11V it will be hard to turn the ignition ON. lf the discharge voltage

continuously stays under 11V it means the battery is aging and

replacement is needed.

Ÿ Starting Voltage: During ignition, the voltage will drop to a certain

point, at this minimum point is Starting Voltage (Around 7.5-9.5V). If

the Starting Voltage continuously stay under 7.5V it means battery

capacity is low and needs to be replaced.

Ÿ Charging Voltage: When the ignition ON engine ON. The alternator will

continuously charge the car battery, normally is around 14V.

Battery Status corresponding with Battery Voltage (Before Ignition)

Battery Voltage

<10.8V

10.8V-11.8V

10 16

Battery Status

Too Low

Slightly Low

Effects and Measures

Hard to start vehicles replace battery

Hard to start vehicles