Major tech MT933 Gebruiksaanwijzing - Pagina 4

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Major tech MT933. Major tech MT933 16 pagina's. Cable length tester

Major tech MT933 Gebruiksaanwijzing

1. DESCRIPTION

• The Cable Length Meter is a hand-held testing device with the following
measurement capabilities: resistance, temperature and length.
• They can be used as mΩ meters to measure precise bonding
resistances.
• The primary function of these meters is to calculate the length of cable
based upon its material, temperature, and cable gauge, Cable material
type can be either uncoated copper or aluminum.
• There are 20 pre-programmed and eight programmable cable gauges.
(There are no strands per cable specification for the eight programmable
switch positions.)

2. SAFETY INSTRUCTIONS

WARNING: observe the instructions given in this manual;
improper use could damage the instrument or its components.
Double-insulated meter
• Do not connect this unit to live voltage.
• Do not expose this unit to rain or moisture.
• Do not use the unit if it is wet or damaged.
• Do not operate with the case open.
• Do not attempt to repair this unit. it contains no user serviceable parts.
• Do not expose the unit to extremes in temperature or high humidity,
Refer to "Specifications."
• Before opening the case, remove the test leads from the circuit and shut
off the unit.
• Using this unit near equipment that generates electromagnetic
interference can result in unstable or inaccuratereadings.
• Inspect the test leads or accessory before use, they must be clean and
dry, and the insulation must be in good condition.
• Use this unit for the manufacturer's intended purpose only, as described
in this manual, any other use can impair the protection provided by the
unit.
• Failure to observe these warnings could result in severe injury or death.

3. GENERAL DESCRIPTION

The instrument carries out the following measurements:
1. Twenty measurement gears in line with industry standards: 0.15, 0.25,
0.5, 0.75, 1, 1.5, 2.5, 4, 6, 10, 25, 35, 50, 70, 95, 120, 150, 185,
240mm².
4