Jam Q10 Gebruikershandleiding - Pagina 4
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Jam Q10. Jam Q10 7 pagina's.
Pagina afdrukken1-3 System Connection – four separate channels to four sets of speakers
In standard operating mode, you can connect 4 different audio sources, one to each channel (A,B,C or D). Connect speakers to
each output channel (A,B,C,D) Use either 2 core cable connected to pin1+ and pin 1- , or 4 core cable where pin2+ and pin 2- are
NOT CONNECTED at the speaker end. Channel B also outputs to pin 2+ and 2- of the output connector for Channel A. Incorrect
connection may damage the amplifier and/or speakers.
Be sure to use a minimum impedance of 2 ohms per channel. (4 ohms recommended for best results)
•
Check your cabling before powering on the amplifier to ensure there are no short-circuits or other cross wiring. Please see
•
the wiring information for bi-amp configuration
When running a multi-way active system, check the correct channels are connected from the processor to avoid the wrong
•
frequencies being applied to your tweeters.
Do not connect/disconnect under load. Always turn down volumes before connecting or disconnecting any inputs or
•
outputs to avoid the possibilities of damage.