Green Frog Designs Chicken Run 6x2 Handmatig - Pagina 14

Blader online of download pdf Handmatig voor {categorie_naam} Green Frog Designs Chicken Run 6x2. Green Frog Designs Chicken Run 6x2 17 pagina's.

FITTING MESH AND NETTING (Optional)

Cut the 1200mm Weldmesh so that it just fits inside the

frame, beside the door. Secure the weldmesh using Cable

Ties (spaced every 5 holes). You can make weldmesh

easier to fit if you remove any curvature. We do this by

lying it curved side upwards on a very flat area of lawn

and carefully walking on it.

Repeat steps 19 and 20 until the frame is filled. If you

wish, you can use an offcut of mesh to fill the gap above

the door (not shown). If you do so, fold 50mm up at the

bottom edge, as this will to provide added rigidity and

avoid exposed wire ends.

Cut away segments at the corners so that the mesh is

clear of the hinges, top and bottom.

Printed on recycled paper

Fill all remaining gaps in the frame with Weldmesh using

Cable Ties. It is best to use 1200mm mesh at the

bottom and 900mm (if supplied with your run) at the top.

Cut Weldmesh to fill the entire door frame, and fit it

loosely in place to the inside of the door with a cable tie at

each corner. You may have to do this using two pieces of

mesh.

Cut away segments so the door catch can slide between

its open and closed positions. Ensure there are no sharp

edges left here (file off any exposed wire, or fold back

25mm of the mesh rather than cut it exactly).

– same for all run sizes

Page 14 of 17